To remove the speed sensor on a 1999 Chevrolet S10, first, ensure the vehicle is parked on a level surface and the ignition is off. Locate the speed sensor, which is typically found on the transmission or transfer case. Disconnect the electrical connector by pressing the tab and pulling it off. Finally, use a socket or wrench to unscrew the sensor from its housing and remove it from the vehicle.
It should be mounted into the drivers side rear of the transmission.
there is no such thing as an egr position sensor
It has wrench flats. I think you can rotate it to loosen it.
Yes, it's in the passengers side of the engine block towards the rear, probably best reached from underneath.
The vehicle speed sensor which is an integral part of the speedometer
remove the 10mm bolt and remove it.disconnect plug at other end.
The axle speed sensor measures the axle speed for ABS functions and for the speedometer.
where is the speed sensor on a 1999 dodge ram The vehicle speed sensor is located on the top of the rear axle. You remove the nut and stud that hold it down and gently twist and pry it out. Be carefull not to break it off.
There are four speed sensors on a 99 BMW 328i. One sensor is located on each of the four wheels.
My buddy has a '99 ZR2 with a 5 speed.
Depends on which engine you have. More info please.
The vehicle speed sensor is the sensor on top of the rear axle. If the vehicle has 4 wheel ABS then there will be a speed sensor on each front wheel.