0
What else can I help you with?
Where is a knock sensor situated on a ford 1.3i rocam engine?
On a Ford 1.3i Rocam engine, the knock sensor is typically located on the engine block, often near the cylinder head. It is usually mounted on the side of the engine, close to the intake manifold. This positioning allows it to effectively detect vibrations caused by engine knock or detonation. Always refer to the specific service manual for the exact location, as it may vary slightly by model.
Can i use computer box for a ford bantam rocam 1.3. on a ford bantam rocam 1.6 engine?
The ECM (Engine Control Module) or PCM (Powertrain Control Module) may appear to look the same as others but most are programmed (Flashed) to exactly match the vehicle it is going in.
Ford ikon 1.6i rocam engine will not turn over when key is used but when direct power is connected to starter to battery engine turns over.?
when the temp sensor is faulty the engine wont turn over, replace temp sensor, it is located in the termostat housing, it just plugs into it.
Where can you find a picture of the engine temp sensor location on a 1998 ford contour zetec engine?
Where can i find a picture of the engine temp sensor location on a 1998 ford escort zetec engine?
What is cylinder head torque for ford bantam 1300 rocam engine?
This will vary in the vehicle that is being used. Some of them will use more power than the others.
Where is the map sensor on 5.0 engine?
where is the map sensor on 1995 ford van 150 series, 5.0 engine where is the map sensor on 1995 ford van 150 series, 5.0 engine
What side of the engine would you find the oxygen sensor for bank 1 sensor 2?
On a Ford F-150 , bank 1 is the passenger side of the engine and sensor 2 is in the exhaust pipe after the catalytic converter ( downstream )
Where is the coolant temp sensor on Ford Fusion?
where is the engine mangement temp sensor on a ford focus and how is it fitted
Does a 1993 Ford Aerostar Van have a crank position sensor?
It appears that the Ford Aerostar with 3.0 engine does not have a crank position sensor, but the 4.0 engine does have one.
What is the torque settings for mains and big end bearing on Ford Bantam 1.3i 2003?
The year, make and engine info would help.
Is there a Hugo sensor in a Ford Fiesta engine?
Yes
Where is the throttle position sensor located on a 1995 Ford Escort?
In the Ford Escort LX this particular sensor is typically located in the engine. In particular if you are looking for this sensor it is important that you look on the driver's side of the engine.
