If the overdrive light is flashing on your 2002 Ford Explorer, it typically indicates a transmission issue. First, check the Transmission Fluid level and condition; low or dirty fluid can cause problems. If the fluid is fine, use an OBD-II scanner to check for any diagnostic trouble codes (DTCs) that can help identify the specific issue. If you're unable to resolve it, it's advisable to consult a professional mechanic for further diagnosis and repair.
If the check engine light is flashing that means an engine cylinder misfire has been detected
The flashing red light is for the factory security system that comes with your vehicle, I own a 2002 Ford Explorer and we have the same thing...
No , if the light is flashing that indicates a malfunction
A malfunction has been detected , have it checked by a professional
brake light flashing on 2002 jetta tdi
After the low fuel light comes on in a 2002 Ford Explorer, you should be able to drive at least another 10 miles. The low fuel light usually comes on when there is 2 gallons left in the tank.
To reset the flashing theft light on a 2002 Ford Explorer, first, ensure that the vehicle is in the "Off" position. Then, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the theft light turns off. Finally, turn the key back to the "Off" position and then start the vehicle to complete the reset.
The 2002 Ford Explorer has rear wheel drive.
Take it to a profesional to diagnose / repair !!!!!
A malfuntion has been detected , could be a sensor
If the check engine light is flashing that means an engine cylinder misfire has been detected
If the check engine light is flashing that means an engine cylinder misfire has been detected . You can drive it in for repair , just avoid any rapid acceleration or deceleration because you can damage the catalytic converter