answersLogoWhite

0

If it is to loose when you pull the parking brake handle = tighten the bolt that is under the panel that surrounds the parking brake handle on the floor. If it's not the handle there is a wire hooked to an fork with an spring load on each rear brake fundament. Look from behind on the inside of the brake disc and see that the wire is a tight and tension loaded fit. None the above, make sure the brake pads are in recommended value (6 mm thickness of lining with the metal plate)

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Why does the parking brake warning light on my 1993 Ford Probe remain on even after the parking brake is off?

This light is for brake on/problems with the brake. Check your brake fluid level and ensure it isn't dipping below the sensor on the master brake cyllinder. I had this happen to me during winter.


How do you remove rear brake lens on 1993 ford probe?

The 1993 Ford Probe rear brake light lens cannot be removed. The tail light are a complete seal light. The light bulb's can be removed from the rear of the light assembly.


Dia gram of starter location 1993 ford probe?

diagram of starter in a 1993 ford probe


How do you adjust the parking brake on a 1993 Ford Mustang?

At the "Y" of the cables under the car in front of the rearend.


How to Replace parking brake cable 2003 Ford Escape?

video on how to replace parking brake cable in ford escape 2003


Factory rim width on 1993 Ford Probe gt?

ford probe gt rims are 7 inch


Where do you locate the fuel pump on a 93 Ford Probe?

Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder


Why does the parking brake light come on on a 2003 Ford Explorer?

The parking brake light comes on when you engage the parking brake. Pull the parking brake release handle. ------------------------------------------------------------------------------- the brake light also comes on if the brake fluid level in the brake master cylinder is low ( in your engine compartment )


Where do you put brake fluid in a 1994 Ford Probe?

The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.


How do you release a parking brake on a Ford Expedition?

where is says; parking brake release on the left side, lower dash, pull it.


What does brake pi light mean on dash of 95 ford probe?

it needs brake fluid


Ford van parking brake wire?

Underneath.