It can need a new slave or master cyl. TAke it to a garage as it is hard to bleed and to work on.
Trouble code P1887 means:TCC release switch circuit
If memory serves me right, you press in on the collar at the cylinder and hold it in while you pull on the line.
Push back on the lower section of the seat (difficult) to release locking clips Lift bench up and out
To remove the ignition tumbler from a 1997 Chevrolet Cavalier, first disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by taking out the screws. Insert the key and turn it to the "Run" position, press the release pin or tab located on the ignition cylinder, and pull the tumbler out. If the tumbler doesn’t release, you may need to rotate the key slightly to find the proper alignment.
I'm not sure what you mean by breaking, but i have a 95 cavalier, and sometimes, if the trunk release is not all the way down, the trunk lid will bounce back up....i just push it down and the trunk shuts easially every time hope this helps
The Cavalier's Dream - 1898 was released on: USA: December 1898
Tango Cavalier - 1923 was released on: USA: September 1923
The Cowboy Cavalier - 1928 was released on: USA: 29 January 1928
A Barnyard Cavalier - 1922 was released on: USA: 8 January 1922
The Spanish Cavalier - 1912 was released on: USA: 9 April 1912
To remove the rear seat from a 2002 Chevrolet Cavalier, first, locate the rear seat bottom's release levers, typically found at the front edge of the seat. Pull the levers to release the seat bottom and then lift it out. For the rear seat back, look for bolts or clips at the base of the seat, remove them, and then tilt the seat back forward to release it from the vehicle. Always refer to the owner's manual for specific instructions and safety precautions.
The Cavalier - 2006 was released on: USA: 13 October 2006 (Dixie Film Festival)