To remove the rear seat from a 2002 Chevrolet Cavalier, first, locate the rear seat bottom's release levers, typically found at the front edge of the seat. Pull the levers to release the seat bottom and then lift it out. For the rear seat back, look for bolts or clips at the base of the seat, remove them, and then tilt the seat back forward to release it from the vehicle. Always refer to the owner's manual for specific instructions and safety precautions.
How do you remove the rear seat on a 2002 diamante
The rear seat on a 2002 Hyundai has bolt behind the seats. Push the seat down to reveal the bolts, and loosen them. The seat will be able to be removed from the vehicle.
Push back on the lower section of the seat (difficult) to release locking clips Lift bench up and out
In a gas tank. you have to remove rear seat.
To remove the 2002 Hyundai accent rear seats find the tabs that cover the bolts and unbolt them. After the bolts are out lift the seat to remove it from the car.
It is behind the rear seat. You have to remove the seat to access.
2 Dr models, You must start with the door kick panels then remove the seat belts then the rear side panels then you can go after the rear dash.
The battery is under the rear seat cushion. # Push in and up on the front of the rear seat cushion. # Lift up and out on the seat cushion. # Remove the rear seat cushion from the vehicle
Seat bottoms just pop up, has clips. seat back have bolts to remove. Need to remove bottom first.
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
To remove the rear seats from a 2002 S430, start by locating and removing the bolts securing the seat bottom; these are usually found at the front of the seat. Once the seat bottom is detached, you can access the rear seatback. Remove any bolts or clips holding the seatback in place, typically found at the base or behind the seat. Gently lift the seatback upwards and out of its mounting points to complete the removal.
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm