There will be a cover on the end where the arm connects to the motor. If you remove that small plastic cover there is a 13mm nut threaded onto a bolt. If you remove that bolt and other hardware that follows you can easily remove the wiper arm.
Need to know what year.
Need to know what year you have.
Lift wiper arm up off windshield it will only go a few inches then stick small screwdriver thru small holes at base of wiper arm to keep tension off and the arm should pull right off worked really easy.
The whole end is the cover, under it there wil be a nut. Pry the cover off, loosen the nut and jiggle the arm. Off it comes!
go to http;//en.wikipedia.org/wiki/chevrolet s-10
Lift wiper arm so that it is at about a 90 degree to the windshield. It should stay there. Now look near the base. There should be a little lever. You should be able to fit a screwdriver between it and the wiper arm. Pry the lever sideways and once it opens up a little you should be able to lift the wiper arm right off.
at the base of the wiper arm is plastic it looks metal but it isn't remove it with a flat head screw driver then use a 1/2" wrench or sockett to remove the nut and the arm will come off at the base of the wiper arm is plastic it looks metal but it isn't remove it with a flat head screw driver then use a 1/2" wrench or sockett to remove the nut and the arm will come off
To remove the wiper arm from a 2004 Chevy Silverado 1500, first, lift the wiper arm away from the windshield. Then, locate the small cap at the base of the wiper arm and gently pry it off with a flathead screwdriver to expose the mounting nut. Use a socket wrench to remove the nut, and then pull the wiper arm straight off the wiper shaft. Be careful not to damage the windshield or the wiper motor during this process.
yes
If only one wiper is working then you have a linkage problem. There is an arm that runs from one side to the other. It has bushings that wear out. You can also have a stripped spline where the wiper arm hooks up.
To replace the windshield wiper arm on a 2005 Chevy Cavalier, first, lift the wiper arm away from the windshield. Locate the small tab or clip on the underside of the wiper arm where it connects to the wiper motor shaft and press it to release the arm. Once detached, position the new wiper arm onto the shaft, ensuring it's aligned properly, and push down until it clicks into place. Finally, lower the wiper arm back onto the windshield and test its movement to ensure it’s functioning correctly.
How much torque do I use to tighten the idler arm