A 2001 Dodge truck does not have a speedometer cable.
The speed signal comes from the rear axle speed sensor. (the sensor on top of the center of the rear axle)
The speedometer does not have a cable on a 1994. It is run by a sesnor on the rear of the trans/t-case.
Speedometer cable replace 1989 toyota
To change the speedometer cable on a 1990 Toyota truck, disconnect the cable, feeding it through the grommet, then disconnect it from the transmission. The process can then be reversed with the new cable.
The exact location of the speedometer cable is dependent upon the make and model of your 1994 pickup truck. In general, the speedometer cable goes from the speedometer to the speed sensor.
There are two types of speed sensors and you can't tell until you look. One is electrical/magnetic (VSS) and one is a cable that goes directly into the instrument cluster. Here is my answer to How to replace the Speedometer Cable in a 1990 Toyota 4x4 Pickup 3.0 3VZE V6. To remove the cable you will need to unhook the e-brake assembly and seperate the speedometer cable from the e-brake at the firewall by the gas pedal. On end goes to rear of the instrument cluster and the other end attaches to a small gear at the rear of the transmission. The instrument cluster will need to be removed.
If the grinding sound seems to be coming from the speedometer and grinds faster as your speed increases, the likely cause is the speedometer cable. At least some 1990 Dodge trucks (mine) have electric speedometers Len
If the abs light is on, then you might have a rear axle speed sensor issue. If not, then you have a cluster problem.
Possible failed rear axle speed sensor. This truck does not use a cable, the speed signal comes from the ABS.
Try blowing graphite down there.
Nope 91 was the last year of that
The Classic was the FLD132, and no. For one, the speedometer is set according to the gear ratio, tire size, and rear end gear ratio of the truck, and if those vary, the speed won't be accurate.
check if it has a speedometer cable if not the speed sensor needs to be replaced