answersLogoWhite

0

remove the glove box(9 or 10) t-15 torx bits, remove one trx bit from the ecu carraige(white plastic) pull the ecu out, and unclip the 3 connectors.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Will a 1995 Chevy Cavalier ECM fit 1996 Chevy Cavalier?

Yes


Where is the ECM on a 1992 Chevy Cavalier?

under the hood on the passenger side looks like a little grill with a plug or 2 in it !---------------!=! !---------------! !==== !---------------!=! !---------------!=! !---------------! !==== !---------------!=!


How do you install a computer into a 1991 Chevy cavalier rs?

Unhook the battery. Remove the glove box door. You'll see the ECM. Unplug the wires to it. There are four nuts that hold it in. Loosen them and take out the ECM. Reverse the procedure to install. Remember to put your original PROM chip in the new ECM.


Where is the ecm located on 1991 Chevy Cavalier?

Behind the glove compartment.


Where is the ECM located in a 1992 Chevy S10 blazer?

The ECM on a 1992 S10 Blazer is located below the glove box.


How fast does a 1989 Chevy Cavalier go?

The ECM will be programmed to shut it down around 105 mph.


Where is ECM computer on 1992 Chevy Astro?

behind right kick panel


Where is the ECM located on a 1997 Chevy Cavalier?

IT IS LOCATED INSIDE THE PASSENGER SIDE FENDER WELL BEHIND THE BUMPER COVER.


Where is the ecm located on 1997 Chevy Cavalier?

IT IS LOCATED INSIDE THE PASSENGER SIDE FENDER WELL BEHIND THE BUMPER COVER.


Where do you find the engine control module at on a 1994 Chevy cavalier?

remove glove box panel ecm is located behind panel


Where is the ecm located in a 1992 Chevy s10 pickup?

Inside the dashboard, to the right of the glove box.


How do you replace the ecm on a 1993 Chev Cavalier?

To replace the ECM (Engine Control Module) on a 1993 Chevy Cavalier, first disconnect the battery to ensure safety. Locate the ECM, typically found under the dashboard or near the passenger side firewall, and remove any mounting screws or brackets. Disconnect the wiring harness and any connectors attached to the ECM, then remove the old module. Install the new ECM by reversing the steps: connect the wiring harness, secure it with screws, and reconnect the battery. Finally, ensure the vehicle is running properly and check for any diagnostic trouble codes.