If it is a V-8 Then there are 2 of them and they both are underneath the intake manifold.
You will have to remove the intake to even see them.
The V-6 is screwed into the transmission mounting flange on the top left rear corner of the engine just below the oil sending unit. You will have to climb up and lean over the top of the engine to see it. HARD TO SEE.
To change the knock sensor on a 2000 GMC Sierra V6 4.3, first disconnect the negative battery cable to ensure safety. Locate the knock sensor, which is typically found on the engine block, near the intake manifold. Remove the electrical connector and unscrew the old sensor using a socket wrench. Install the new sensor by screwing it in place, reconnecting the electrical connector, and then reattaching the battery cable.
Location of knock sensor 1991 GM sierra 350 2500?
where is knock sensor on a 2001 sierra 5.3 2wd 1500.
The knock sensor is located under the Intake Manifold and there is a knock sensor 1/ knock sensor 2 on this model,the 2 is the one in the rear.
i know what the part looks like but i cannot locate it on the engine.
i need to locate knock sensor on a 2000 infiniti g20
that the knock sensor does
knock sensor location is under the intake manifold you have to remove intake their is two knock sensors front and rear
The knock sensor is on the starter side of the engine. It is abut half way between front and back.
As you are looking at your truck from the front the knock sensor shoud be on the passenger side right under the manifolds
the knock sensors are located in the top of the engine block. The intake has to be removed to get to the sensors.
Were is locate the snock sensor of chevi malibu 99