Felpro sells a gasket set for this problem part number ES72671
Remove the oil filter there are two hex screws that are 1/4 inside the housing remove these. You may have to wiggle the housing a little to get it loose.
There are also two oil cooler lines running to the housing you can remove both, I only removed the top one. There is a place for the O-Ring on the housing,the gasket goes on top of the housing.
Yes. It's very easy.
it was recovery to help rebuild and build new housing
A lot depends on your location and the type of rebuild you're planning. In my area of the mid-atlantic states a stock rebuild from a transmission shop including installation would run about $1500.
A complete rebuild with installation will probably cost around $2,300 USD.
The normal problems with the pull down motor is the plastic gear or housing on the bottom. The rebuild is simply swapping the parts and takes only a few minutes. eBay usually has several rebuild kits available with the proper gear and housing or replacement pull down motors.
The only why to repair the seat belt (retractor) is to replace the assembly,no parts are available to rebuild this assembly.
Timing chains are designed to last the life of the engine and are normally replaced during a complete engine rebuild.
You need to take it back to the person that built it, and tell them to fix it.
The Japanese need the support to rebuild homes , bridges , roads , housing , water , food , clothing , medical supplies , etc . . .
CHEVY guit using carburetors back in 1987. You truck is fuel injected / TBI. Throttle body injection.
The cost of rebuilding a 94 accord lx transmission should be around 1200 dollars. ThatÊis inclusive of the tax plus the installation.
Rebuild kit should come with instructionsMotorcycle carb rebuild kits do not come with instructions.You should have the service manual for your bike, which covers carburetor removal, dis assembly, reassembly, and re installation. Rebuilding is essentially taking it apart, being very careful to keep everything in order, cleaning everything good, and re assembling. Ifyou want to install a rebuild kit, just put the part from the kit where it came out of your carb once it's cleaned.