answersLogoWhite

0

To program a key fob for a 1997 Dodge Dakota, start by sitting in the driver's seat and closing all doors. Insert the key into the ignition and turn it to the "On" position (not starting the engine) three times within 10 seconds, ending in the "On" position. This should trigger the vehicle to lock and unlock the doors, indicating it's in programming mode. Finally, press and hold the lock and unlock buttons on the key fob simultaneously for about 15 seconds until the doors lock and unlock again, confirming the fob is programmed.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

How do you disarm your security system on a 97 olds aurora?

To disarm the security system on a 1997 Oldsmobile Aurora, simply press the red button on the key fob. If the key fob is not available, insert the key into the ignition and turn.


How do you reset the fob for vectra 97 when just put new battery in it?

Insert key into ignition,turn to position 2,press 'unlock' on fob. Syncronization complete.


What are the numbers on the back of the remote that I need for my 97 Monte Carlo Ls key fob?

In most cases if you call your local Chevrolet dealer, give the parts dept. your VIN (Vehicle Identification Number) you can order a key fob for that car.


1996 mercury villager will not crank?

You probably need the original key fob for the car. This is regardless if you have an alarm for the car. I've changed the battery twice in the last five years for my 97 Villager and each time I've had to "reset" the "alarm" via the key fob. The last time, I had to uncable the battery twice because it would not "reset" using the key fob before finally accepting the "unlock/disarm" from the key fob.


How do you get the doors unlocked on a 97 Camry when the key fob won't work even with new batteries in it?

Insert the key into the door lock on the drivers side and turn. The door will unlock.


How do you program my 97 lincolin mark VIII key fob?

Key Programming -- SpareCycle the ignition switch from OFF to RUN using a programmed key. After the anti-theft indicator goes off, remove the key.Within 15 seconds, insert a new encoded key into the ignition. wait till the anti-theft indicator goes off, turn key to Run/ START


How do program a new key to a 97 mercury villager?

Go to a Ford dealer.


Changed battery in 1997 mercury villager now wont start lights come on and starter is good What is wrong?

You probably need the original key fob for the car. This is regardless if you have an alarm for the car. I've changed the battery twice in the last five years for my 97 Villager and each time I've had to "reset" the "alarm" via the key fob. The last time, I had to uncable the battery twice because it would not "reset" using the key fob before finally accepting the "unlock/disarm" from the key fob.


How do you program a key for a 97 Pontiac Bonneville?

do s&m with ur husband all night then finger him in the but


Will 97 Dodge Dakota trans fit in a 96 Dodge Dakota?

yes


Will a 94 Dodge Dakota intermediate shaft fit in a 97 Dodge Dakota?

No


How do i reprogram a 97 lumina key?

only a dealership will be able to do this the key has a ohm rating in the chip that the car key solenoids corresponds with you would have to take it to the dealer if its a new key so they can program the chip in the key