To program a key for a 1999 Infiniti I30, you'll need a working key and the new key you want to program. Insert the working key into the ignition and turn it to the "On" position without starting the engine. After 10 seconds, turn the key to the "Off" position and remove it. Then insert the new key and turn it to the "On" position; it should be programmed after a few seconds. If unsuccessful, you may need to consult a professional locksmith or dealership for assistance.
You don't.
purchase and program new key remotes
Replace the starter
MAKE/MODELYEARSInfiniti I30 I 30PROGRAMMING: INFINITI I30 1996-99A MAXIMUM 4 REMOTES CAN BE PROGRAMMED- GATHER ALL REMOTES- CLOSE AND LOCK ALL DOORS- INSERT KEY & REMOVE IT FROM IGNITION SWITCH MORE THAN 6 TIMES WITHIN 10 SECONDS- INDICATORS WILL FLASH 2 TIMES- ORIGINAL REMOTES ARE NOW ERASED- INSERT KEY INTO IGNITION SWITCH & TURN TO ACC POSITION- 1996: PUSH LOCK BUTTON ON 1ST REMOTE TO BE PROGRAMMED- 1997 - 1999: PRESS LOCK BUTTON ON 1STREMOTE YOU WISH TO PROGRAM- INDICATORS WILL FLASH TWO TIMES TO INDICATE CORRECT PROGRAMMING- NEXT REMOTE:- UNLOCK THEN, LOCK VEHICLE USING THE DRIVER'S SIDE DOOR LOCK/UNLOCK LEVER- 1996: PRESS LOCK BUTTON ON 2ND REMOTE YOU WISH TO PROGRAM- 1997 - 1999: PRESS ANY BUTTON ON 2ND REMOTE YOU WISH TO PROGRAM- INDICATORS WILL FLASH TWO TIMES TO INDICATE CORRECT PROGRAMMING- Repeat above (from next remote down) for the remainder of remotes.- EXIT PROGRAMMING: OPEN DRIVER'S DOOR- CHECK TO BE SURE ALL OPERATIONS ON ALL REMOTES WORK.
go to corvetteforum.com and they have the answer
just shoutdown the key...
Many locksmiths will be able to help you and at reasonable cost. After thet cut the blank key with a small hand held computer they program the new key to the vehicle ( not even 5 min. per key) i have paid in FL 60 bucks per key all inclusive!!!
As far as I know, you need the Nissan consult device for that. Take it to the Stealer.
Dealer only on 96+ newer Jeep Grand Cherokee's
Dealer only on 96+ newer Jeep Grand Cherokee's
Dealer programed, can not be done without scan tool
how do you program key