0
I don't have a Ram 3500 but do own a 1996 V10 Ram 2500 the rotors can be a real pain. They say you can hammer them off but that didn't work for me I removed the main axle nut and put to floor jacks pried against the frame and that popped of the rotor. Gook luck it's a pain, very stupid design dumb engineers.
What else can I help you with?
How do you remove front rotors on your Dodge 3500 4X4?
To remove the front rotors on a Dodge 3500 4X4, start by safely lifting the vehicle and removing the front wheels. Next, detach the caliper by removing the caliper bolts, then hang the caliper out of the way without stressing the brake line. Remove the caliper bracket if necessary, and then pull the rotor off the hub; if it’s stuck, gently tap it with a hammer. Finally, ensure all components are clean and inspect for wear before reassembly.
How do you remove the front brake rotor on a 1999 dodge four wheel drive?
first take off frontwheel then take off brake caliper then rotor will pull right off .
Change front brake rotors on 1997 Dodge Intrepid?
Remove caliper, pull rotor off hub, push new one on.
Need help on how to get the front hub off 3500 4x4 dodge 1996?
To remove the front hub on a 1996 Dodge 3500 4x4, start by lifting the vehicle and securing it on jack stands. Remove the wheel and tire, then take off the brake caliper and rotor to access the hub assembly. Unbolt the hub from the steering knuckle, typically requiring a socket or impact wrench, and disconnect any ABS sensor wiring if present. Finally, gently tap or pull the hub off the spindle to complete the removal.
How do you change a Dodge Ram 5.2L distributor rotor?
remove the distributor cap and grab the rotor then pull straight up.
Where is the camshaft position sensor on a 1999 Dodge Ram 2500?
under the rotor in the distributor unplug the wires take off the rotor and pull it out
How do you replace the filter inside the canister on a 2007 dodge 3500?
The fuel filter will pull out of the canister when removed.
How do you replace a rotor drum assembly on a Dodge 3500 series?
It's either a rotor (disc brake) or drum (Drum brake) either way you have to remove the wheel for both, for drum it takes a firm rap with a dead blow around the side of the drum and then should pull off. For Disc Brakes you remove the caliper and pads the the same goes for the rotor gentle tapping on the back side and it should come free. The rotor is bolted to the inside of th e wheel hub on a 3500. You need to remove the brake caliper, axle shaft, and wheel hub.
How do you remove the front rotor from 2004 Sunfire?
pull the wheel off, remove the two caliper bolts, remove the caliper and the rotor can be removed
How do you change front rotor 1995 Isuzu Rodeo?
Remove caliper and pull rotor off the hub. Push new one on, replace caliper and pads.
How do you pull a 5.9 cummins out from a 1992 dodge?
take the front clips out so you can take the front finders off
How do you remove the brake rotors on a 96 dodge ram 2500 4X4?
pull the wheel, and the caliper, you do not have to pull the big nut in the middle. after pulling the caliper the rotor will slip right off.
