To put a driver's side window back on track on a Ford Expedition you will have to reseat the window. Do this by removing the door panel and putting the window back in place. You can use silicone or Gorilla glue to attach the window. Leave the window in the up position for at least one day once you have it back on place.
To put a passenger side window back on track on a Ford Expedition you should first carefully remove any old silicone. Next put the window back on track, and use Gorilla glue or silicone to secure it. Do not put the window down for at least 24 hours.
Take door panel off. and put window back on track.
there should be a latch or your drivers key will open it
you cannot put the window "back on track" the window regulator failed and will need to be replaced, good luck. What kind of lame answer is that? Yours might have been - not everybodies is.
Remove the drivers side inside door panel. Remove the retaining clips from the window track. Place the new window in the window track and tighten the retaining clips.
When a window goes off track on a 2004 Grand Am GT, the door panel has to be removed. The cable for the window is then reset on the track or repaired and the door panel put back on.
Take off the inner door panel then remove them insulation plastic then reach inside and adjust it back on track feeling it with your hands
Remove the inside door panel. The entire power window mechanism will be visible. Put the window back onto the window track.
probably have broken part in window assy. that is covered by recall. take it to the dealer.
To set the power window back on track in a Ford Focus, you have to remove the door panel. Once you get in there, you will see the track that you will need to put the window back on.
If I remember correctly the amp is in the back behind the panel below the rear window on the drivers side.
I have the same problem on my 1998 Ford Expedition XLT. I have put it back on track about 5 times and keeps coming off again and again. I'm going to use the same glue the windshield installers used. I'm going to buy a tube of the glue from them, this will resolve the window from coming off track.