answersLogoWhite

0

To recharge the air conditioning on a 2002 Ford Excursion, first, locate the low-pressure service port, typically found on the larger diameter aluminum line near the firewall. Use a refrigerant recharge kit, ensuring you have the correct type of refrigerant (R-134a for this vehicle). Connect the recharge hose to the low-pressure port, start the engine, and turn the A/C to maximum. Follow the instructions on the refrigerant can to add the refrigerant until the system reaches the recommended pressure.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Is your 2000 ford excursion r-12 or r-134a?

A 2000 Ford Excursion would be ( 134a ) in the air conditioning system


Where is the air conditioning recharge valve on a 2003 Ford Explorer 4.6?

The air conditioning recharge valve on the 2003 Ford Explorer 4.6 is located on the low pressure side of the air conditioning system. Located on the line coming from the accumulator to the compressor is the recharge valve.


What size is the gas tank for a 2002 ford excursion?

According to the 2002 Ford Excursion Owner Guide : ( 166.6 litres / 44.0 U.S. gallons )


Is there an access panel to the fuel pump on a 2002 ford excursion?

No


Where is the OBD port on 2002 ford excursion?

The 2002 Ford Excursion OBD 2 port is under drive side dash above accelerator


What fuse is for the turn signals on a ford 2002 excursion?

According to the 2002 Excursion Owner's Guide, it should be a 20A fuse in fuse location #18.


What is the lug pattern on a 2002 Ford Excursion?

8 x 170mm


What oil filter for your 2002 ford excursion?

Motorcraft FL-1995


What type of power steering fluid does your 2002 ford excursion use?

According to the 2002 Ford Excursion owners manual : Motorcraft MERCON automatic transmission fluid is used as the power steering fluid


Cost of full tune up for 2002 ford excursion v10?

About $300.00


Where do you recharge air in a 2002 ford explorer?

To recharge the air conditioning system in a 2002 Ford Explorer, locate the low-pressure service port, which is usually found on the larger diameter aluminum line between the evaporator and compressor. Remove the cap from the port, then connect the refrigerant recharge kit to the port. Follow the instructions on the recharge kit to add refrigerant to the system, ensuring you check the pressure with a gauge to avoid overcharging. Always refer to the vehicle's manual for specific details and safety precautions.


How do you replace the wheel gear box on a 2002 ford excursion gear box?

need to replace the wheel gear box on a 2002 ford excursio.