0
To remove the glove box from a 1997 Chevrolet Silverado, start by opening the glove box and removing any contents. Next, locate and remove the screws securing the glove box to the dashboard; these are typically found on the top and bottom edges. Once the screws are removed, gently pull the glove box towards you to release it from its hinges, and disconnect any clips or wiring if applicable. Finally, lift the glove box out of the dash to complete the removal.
What else can I help you with?
How do you remove a non locking glove box latch on 1979 silverado?
The 1979 Chevy Silverado glove box latch is held in place with two retaining screws. Remove the retaining screws and the glove box latch will come off.
Were is the blower motor resistor located on a 1997 Chevy 1500 silverado?
On the passengers side, remove the glove box and door and its mounted to the top of the a/c heater box by two screws..............
Where is the ECM on a 92 silverado?
Remove the inside of the glove box and then look in to the bottom right side and you will see it.
Where is the cabin filter in a 1997 Mercedes e320?
You will need to remove the glove box assembly. There is a door behind the glove box where the filters are located.
Where is the ECM located on a 1997 Chevy pickup truck with a 350 engine?
behind the glove box on passenger side...you will have to remove glove box to get to it
Where is the cabin air filter located 1999 silverado?
Try under the glove box where the ducting is, you have to remove a screw or two.
How do you remove a glove box from a 1993 Toyota Camry?
how to remove my glove box
How do remove the glove box on a 1993 Camry?
how to remove glove box in 1993 camry
Where is the fuse box in a 1997 VW Polo?
hi. Remove the glove box under the steering wheel by pressing the clips at the left and right hand side of the open glove box. The fuse box is behind this.
How do you replace a blower motor resistor 1997 Honda passport?
Resistor is located behind glove box. Remove 2 screw at bottom of glove box which attach hinges. Glove box comes right out. The resistor will be directly behind glove box. It will have a plug and 2 screws which hold it in place. Remove plug unscrew and pull out. Install in reverse order.
How do you remove the Glove Box in a 1997 Chevrolet Cheyenne 1500?
1. Remove contents of glove box 2. When all the way open, there are two catches at the top corners of the box, you must squeeze them in to let the box open completely. 3. Remove the screws on the hindges, and it should come right out.
How do you remove the glove-box in a 95 C1500?
Assuming it's the same as a 94 C1500, Open the glove-box, remove the screws across the top and bottom, remove the cables that support the glove-box door, remove the glove box door, remove the glove box compartment. I have a 95 K1500, you just have to squeeze the top of the glove box, clear the mount and then remove the plastic strap on the left side, and then open the glove box fully it just fall down, no need to unscrew anything.
