First you need to remove the ashtray (pull it open and push down on the little tab on the top and pull it out) then you have to pry on the trim. Do this slowly as you could break it. it will take a good pull. (it's just clipped on) then remove the moulding that goes around the astray/lighter area. This is done by removing 4 screws (2 on the top sides and 2 located on the bottom at the back. look close they're there) then you will have free access to the 2 bolts holding in the radio. nothing really tricky about it except trying not to break the first trim piece.
How do I change th starter on a 1994 Plymouth sundance
Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.
No. It Is Held In Place From The Bottom .
No, it is not an interference engine.
you need a 10 amp (red) fuse for the radio. the fuse is located in the top right fuse corner of the fuse panel. it is marked radio underneath the fuse.
The codes on a 1994 Sundance are 2 digit codes. Code 3 is not correct.
in the fuse box
You can purchase a dipstick from the dealer.
It is screwed into the exhaust manifold on the rear of the engine.
A 1994 Plymouth Sundance/Duster does not use a speedometer cable. Instead, it uses a Speed Sensor located on the transmission.
Front camber is adjusted at the strut to knuckle bolts.
passenger side rear next to fuel tank