Before the key will come out of the lock.
The Keyway should be in the vertical position, the same position it was in when
the key was put into the lock.
Caution:
Be very careful not to damage the dust shutter door
at the entrance to the keyway.
It is held in place by a small hinge pin and spring.
If it breaks, remove the parts from the keyway.
Locksmiths: Have experience and tools for broken key removal.
AAA Automobile Club locksmiths, may be a good choice.
To remove a trunk lock from the outside of a car, start by opening the trunk and locating the screws or bolts that secure the lock mechanism. Depending on the model, you may need to remove the interior trunk lining to access these fasteners. Once exposed, use the appropriate tools to unscrew or unbolt the lock assembly. Finally, disconnect any wiring or clips if the lock has electrical components, and gently pull the lock out from the trunk lid.
car trunk lock replacement trunk opening chip car key Fob Keys key broken off key stuck
car trunk lock replacement trunk opening chip car key Fob Keys key broken off key stuck automotive key extraction
It is manual, there is no trunk button whatsoever on the inside of the car, you need the key to get in. The lock on ours was broken, so we had to drill through the destroyed lock to open it :D
Sorry, but your question makes no sense at all. What does a trunk lock have to do with your car starting or not.
Transponder Car Keys- Car Lock Repair- Car Door Opening- Lost Car Keys- Ignition Car Keys- Broken Car Key Removal- Trunk Opening- Change Residential Locks- Lost House Keys- Home Lock Rekey- Deadbolt Installation- Residential Lock Repair- Patio Door Locks- Master Key Systems- Access Control Systems- Broken Office Key Removal- Lost Office Keys- Safe Opening- Keyless Entry- Commercial Lock Repair- Emergency Lockouts
The rear "trunk" (decklid) release mechanism is an option, if equipped, and is located on the right side of the dash protrusion on the dash. It will be a switch that shows an opening "trunk". If this switch is not there, then the car was not equipped with rear trunk release. If you are trying to get into a Fiero trunk that does not have a decklid release mechanism or a broken one, and you have lost the keys, then you will have to actually break into the car to open the trunk. Typically, if the outer key switch is remove, you can insert a long screwdriver into the hole and pop the trunk lock.
Emergency Car Key Replace, Extraction of broken keys, Emergency trunk opening, New lock installation, Transponder Chip Key, High security locks, Lock repair, Car Locked Out,
grab the end of the key sticking out and pull straight back.
On the inside of your trunk lid locate the lockcylinder. There is a thin metal retainer which holds the cylinder in place, it has a small tab sticking out. Pull the retainer out and the cylinder will slide out .
Lucky you, you get to pull the back seat out and pull two or three bolts to remove the back pad on the back seat and go in from the inside of the car... or you could call a locksmith. However, there is usually a trunk relase in the glove box of the car...
Remove the rear seat to access the trunk and repair the lock assembly.