To remove a Dodge Dakota tailgate, start by ensuring the tailgate is in the open position. Next, locate the hinge pins on both sides of the tailgate and use a socket wrench to remove the bolts securing them. Once the bolts are removed, carefully lift the tailgate off the hinges. Finally, if necessary, disconnect any wiring for the tailgate light before fully removing it from the vehicle.
No they won't. They completely changed the Dakota bed in 1997
No the tail gate will not fit, they are different
On 2000 Dakota Sport you lower the tailgate and there are 2 Phillips head screws that you remove and the whole tail light module comes out. You can then remove the bulb socket and replace the bulb. On my 2002 Dakota Quad Cab there are 2 torx screws.
The tailgate on a 2004 Dodge Ram pickup can be removed by removing the gate from the hinges holding it in place. Open the tailgate halfway and remove the slotted hinge from each side while holding the gate up. Then open the tailgate all the way and slide the tailgate off.
How do I get to the flywheel bolts on a 98 dodge dakota to remove a transmission
Look under the left side and unplug the taillight connector. On the upper end of each support cable push tab and release cable. Remove bottom right side of tailgate by pulling it toward you. It is slotted and will pull out when the tailgate is at the correct angle. Once that is released slide the tailgate to the right to release the left side. One strong person can do this but two is makes it eaiser. Be careful it is heavy.
To remove the tailgate from a 2013 Dodge Ram 1500, start by ensuring the tailgate is in the fully open position. Locate the hinge pins on either side of the tailgate, and use a flathead screwdriver or a similar tool to gently pry out the retaining clips. Once the clips are removed, lift the tailgate upward off the hinges. Be cautious and have an assistant if necessary, as the tailgate can be heavy.
how do you fix transmission on a dodge ddakota
On 2000 Dakota Sport you lower the tailgate and there are 2 Phillips head screws that you remove and the whole tail light module comes out. I don't think you can replace a single lens, you have to pay for a whole new module.
Apparently for Dodge Dakota's you need a special Door Handle remover tool.
Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.
Not legally.