0
What else can I help you with?
How do you remove crank sensor from Chevrolet astro 93?
That year did not USE a Crank sensor.
How do you remove a crank sensor on a 1997 Chevy blazer?
First find the crank sensor and then kick the crap out of it :D
Where is the crank sensor on a Mercedes e320?
how do i remove the crank senor on the e320 Benz
How do you remove crank sensor on a 2000 Dodge Intrepid?
Disconnect the electrical connector, remove the mounting screw and remove the sensor.
Where is the crank sensor located on a 1995 Oldsmobile Aurora 4.0?
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
How do you change the crankshaft position sensor on a 2001 Pontiac Grand Prix?
remove the front passenger wheel, remove the crank pulley, remove the crank sensor. you may need a GM special tool to remove certain bolts
Where is the location of the Crank Sensor on a 3.1 Corsica Engine?
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
Where is the crankshaft sensor on 2001 Buick Century?
its right behind the harmonic balancer....so you will have to remove the h.b them remove the crank sensor...
Where is the crank position sensor on a 1999 Chevrolet Malibu?
The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.
Where exactly is the 2000 Chevy Impala crank shaft sensor?
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
Where is crank sensor 99 jeep 4.7?
You have to remove the starter and the sensor is behind there in the rear of the engine block.
How do you replace a crank position sensor on a 2000 Grand Prix?
The crank position sensor is behind the crank pulley. You need to remove the pulley, remove the plastic shield and remove two of the lower front cover bolts. Then you can remove the crank sensor. This proceedure is more complicated than it sounds. Check out the following website for a cam install and scroll down to where it talks about removing the harmonic balancer (crank pulley) http://www.mccgp.com/upgrades/caminstall/caminstall.php Hope this helps. "G"
