To remove the AC evaporator case housing on a 1995 GMC Jimmy, first ensure the vehicle is off and disconnect the battery. Remove the dashboard and any necessary components obstructing access to the housing, including the center console and HVAC controls. Disconnect the refrigerant lines, and then unbolt the evaporator case from the firewall. Carefully pull the housing out, making sure to manage any attached wiring and components.
You have to remove the blower motor and housing . Also remove glove box to see what you are doing. Re move the side cover on the evaporator and unbolt evaporator on engine side 2 bolts then pull out evaporator and expansion valve together
To change the evaporator core in a 1995 Camaro, first, disconnect the battery and remove the dashboard for access. Next, drain the refrigerant and remove the heater core and evaporator housing from the vehicle. Replace the old evaporator core with a new one, reassemble the housing, and reinstall the dashboard. Finally, recharge the refrigerant and reconnect the battery, ensuring everything is sealed properly to avoid leaks.
hit it with a hammer....
To replace the evaporator on a 1995 GMC Vandura 2500, start by disconnecting the battery and draining the refrigerant from the A/C system. Remove the dashboard and any components obstructing access to the heater-A/C unit. Unbolt the evaporator from the housing, replace it with the new unit, and reassemble everything in reverse order. Finally, recharge the A/C system and test for proper operation.
To remove the evaporator from a 1995 Buick, first, disconnect the vehicle's battery and recover the refrigerant from the A/C system. Next, remove the dashboard and any components blocking access to the heater core and evaporator. Unbolt the evaporator case from the firewall, disconnect the necessary hoses and electrical connectors, and carefully pull out the evaporator core. Ensure all components are replaced in reverse order and recharge the A/C system afterward.
It is attached to the back wall of evaporator. You have to remove the glove compartment, blower unit and evaporator to get access to the expansion valve.
The expansion valve on a 1995 Toyota 4Runner is typically located in the vehicle's air conditioning system, specifically within the evaporator assembly. It is usually situated inside the dashboard, connected to the evaporator core. To access it, you may need to remove the dashboard or the HVAC housing. Always refer to a repair manual for detailed instructions and safety precautions.
On a 1995 Chevrolet Suburban, the orifice tube is located in the air conditioning system, typically within the liquid line that runs between the condenser and the evaporator. To access it, you may need to remove the dash or some panels to reach the evaporator housing. It's usually found near the firewall, in the engine compartment, or close to the evaporator core. Make sure to discharge the AC system safely before attempting to replace the orifice tube.
Remove the two screws. Then remove the light housing. The bulb is right there, pull it out. Cheers
To remove the air filter from a 1995 VW T4, first, locate the air filter housing, which is usually positioned near the engine. Release any clips or screws securing the housing cover, then carefully lift it off. Remove the old air filter from the housing, ensuring no debris falls into the intake. Finally, clean the housing, insert the new filter, and reassemble the cover securely.
its inside the transmission remove the transmission pan and you will see it the filter snaps in
Remove the water supply hose from the top of your thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out and drop in the new thermostat.