0
What else can I help you with?
How to replace antenna on 1992 Toyota pickup?
remove wheel and remove the plastic liner inside the fender. remove the radio and disconnect the antenna wire. Tape another, 10' long wire to the end of the antenna wire. Unscrew the nut around the antenna from on top. pull the antenna and antenna wire out through the fender. Tape the 10' long wire to the new antenna wire and pull it back through the dash to the radio.
How do you replace the antenna on a 92 Nisson 240sx?
Begin by removing the wiring harness from your 1992 Nissan antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.
How do you remove fuel pump 1992 Isuzu pickup?
Drop the fuel tank or remove the bed.
How do you remove the antenna on a 1992 volkswagen cabriolet?
To remove the antenna on a 1992 Volkswagen Cabriolet, start by unscrewing the retaining nut located at the base of the antenna using a wrench. Once the nut is removed, gently pull the antenna out from the mounting hole. If the antenna is stuck, you may need to carefully wiggle it while pulling. After removal, make sure to seal any exposed holes to prevent water ingress.
How do you replace power antenna on 1992 corvette?
Remove left rear wheel plastic housing cover under the body you can then access the antenna motor.
Where is the fuse that controls the antenna to a 1992 Corvette?
where is the fuse that controls the antenna to a 1992 corvette?
How do you cange a antenna in a 1992 Mercedes 190e?
To change the antenna in a 1992 Mercedes 190E, first, disconnect the negative battery terminal to ensure safety. Remove the interior trim panel around the antenna, then unscrew the antenna base from the outside and carefully pull it out. Install the new antenna by reversing the process: insert it into the base, secure it with screws, and reattach the trim panel. Finally, reconnect the battery and test the antenna to ensure it functions properly.
1992 Jeep Cherokee Limited; how remove and replace failed automatic radio antenna?
I was able to remove the existing power antenna on my '92 Cherokee through the wheel well. You have to remove three of the nuts attaching the plastic to the fender as well as pull out two plastic plugs. Pull back the plastic and you will see the power antenna right there. Good luck, Woody
How do you disassemble the power antenna on a 1992 caprice classic?
To disassemble the power antenna on a 1992 Caprice Classic, first, disconnect the negative battery terminal to ensure safety. Then, remove the inner fender liner or access panel to reach the antenna assembly. Unscrew the mounting bolts or clips securing the antenna and disconnect the electrical connector. Finally, gently pull the antenna out from its housing, taking care not to damage any surrounding components.
How do you replace a CV joint on a 1992 Chevy pickup?
how do you replace a CV joint on a 1992 Chevy pickup?
How do you find AC sensor on 1992 GMC pickup?
Where is the AC sensor located on a 1992 GMC pickup
How do you replace power antenna mast?
how do I replace a power antenna on my jeep Cherokee 1992
