You must remove the transmission, the front differential is built right in.
80w90 The 2004 Rubicon rear differential uses 75W140 synthetic oil. On each side of the differential cover plate is a tag listing specific numbers for the differential. One of the tags lists the lubricant installed by the manufacturer. I also have a 2004 Rubicon and the rear differential on mine uses 75W140 synthetic oil plus 4 oz of limited slip lube. The front differential lists only 80W90 oil with no limited slip lube.
Check on the internet fat cow
To change the front universal joint on a 1997 Yamaha Kodiak ATV, first, remove the front differential cover and drain the fluid. Next, disconnect the driveshaft from the differential and remove any retaining clips or bolts securing the universal joint. Use a press or a specialized tool to remove the old joint and install the new one, ensuring proper alignment. Finally, reassemble the driveshaft and differential, refill the fluid, and check for proper operation.
there should be a square opening on the front differential cover. There, you can install a 3/8 inch ratchet. the plug itself is like a socket.
To pull the front differential axles on a Chevrolet Silverado, first, securely lift the vehicle and remove the front wheels. Then, detach the axle nuts and remove the retaining clips if applicable. Next, disconnect the axle shafts from the differential by pulling them out gently; you may need to remove the differential cover for added access. Finally, ensure you have a suitable container to catch any fluid that may leak during the process.
how do you remove front tire on 02 softail springer
No you can not. The front wheel bearings will come apart and fluid will run out of the front differential.
How do you remove and install front door panel 1985 Nissan Sunny
The front differential is an "open" differential. No limited slip components there.
The front differential uses 80w90.
Remove the tire and wheel. Remove the axle end cap. Remove the bearing seal. Remove the bearing. Reverse the process to install the new bearings.