disconnect battery-crawl underneath,unbolt existing starter,undo related wiring-reverse with new unit,reconnect battery, have a beer
with a hammer
On a 1985 Chevy Caprice Classic, the starter is located on the passenger side of the engine, near the bottom where the engine and transmission meet. It is mounted to the bell housing and can be accessed from underneath the vehicle. To replace or service the starter, it's often necessary to remove the starter wires and the mounting bolts. Always ensure the battery is disconnected before attempting any work on the starter.
Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
Take the positive cable off the battery, then you have to remove the inspection shield on the transmission and then take the two bolts out of the starter
To change the starter on a 1985 Chevy Celebrity: 1. Disconnect the battery ground. Use gloves to avoid getting battery acid on your skin. 2. Raise the car and put on stands. Be sure the parking brake is on. 3. Remove the wires to the starter solenoid. Take note of their routing . 4. Some starters have a brace at the front of the starter, remove it if present. 5. Using an appropriate socket remove the two bolts that hold the starter in place. There may be shims on the starter, if present save them for re use. The starter should now pull forward and then lower it from the engine. Replacement is the reverse of the above.
To replace a starter in a 1985 Olds car, raise the front end of the car with a jack, Next, remove the two support bracket bolts at the transmission and pry the support bracket away slightly to obtain access to the starter bolts.
how do i replace the bendix drive in my 85 harley fxrs
Push the tensioner down and remove belt
Remove the water supply hoses from your 1985 Chevy heater core. Remove the heater core retaining bolts. The heater core will come out. Reverse the process to install your new heater core.
To replace the starter on a 1985 Ford F150, first disconnect the negative battery cable to ensure safety. Next, locate the starter, which is typically mounted on the engine block near the transmission. Remove the wiring harness and the mounting bolts, then carefully pull out the old starter. Install the new starter by reversing the disassembly steps, ensuring all connections are secure before reconnecting the battery.
UNDERNEATH THE ENGINE ON THE PASSENGER SIDE NEXT TO THE OILPAN.
To replace the heater core in a 1985 Chevy van, start by disconnecting the battery and draining the coolant from the radiator. Remove the dashboard and the heater assembly cover to access the heater core. Disconnect the hoses and any attached components, then remove the old heater core and install the new one. Reassemble everything, refill the coolant, and check for leaks before reconnecting the battery.