unbolt the door panel for rear, or loosen clips on front doors. then pop off and there ya go
Try searching removing the door panels. This question has already been answered a couple of times in this forum. If you have any experience at all removing door panels you should be able to figure it out. The bottom on these panels pulls out and then it lifts up, make sure you remove all the screws!!
disconnect neg bat terminal , remove belt , remove cables from alt. , remove bolts holding alt.
remove your door panel remove the rubbers grommets, remove 3 10mm nuts unplug if power, reverse process
How do you replace the heater core on a jimmy?
you have to remove door panel and there are three nuts you have to take off of the mirror.
covered in a manual, if your going to keep it, buy one or check out the local library to see 4 free. d
answer: i just did it today 4/10/08 you have to remove about 10 screws you need a torque wrench set and a 7mm. socket . remove or just loosen up the 2 or 3 bottom panels underneath the steering column the signal relay and hazard relay are right next to each other next to the cigarette lighter housing but behind the panels that you have to remove . i pulled it out with a needle nose plyers. not bad it took me 30 min. or less the relay was $10 at the dealer . i hope this helped you...
Not easy. TAke the door and window handles off then all screws you can find. Then the retainers on the sides and bottom of the door,pull out on the bottom and push in on the top and raise up on hte panel to diaengage from the door. Go to the following website. It will show how to remove the door panel and the side mirror. kwmuth.com
remove serpentine belt center bolt in idler remove, and install new pulleyand rplace belt the way it came off
remove the 2 bolts that hold the thermostat housing to the intake manifold which the upper radiator hose attaches to the housing then just pull the thermostat out and replace.
take off door panel, remove window, remove window sash, unlatch the lock, take the catch pin off, slide out.
Begin by draining the water from your 1999 GMC Jimmy cooling system. Next, remove the belt from your water pump. Third, remove the water return hose. Last, remove the water pump retaining bolts. Reverse the process to install your new water pump.