pry up the cover from the outside of the handle and remove the 7 mm screws front and back
You will need to remove the inside door panel. Remove the door handle retaining screws. Remove the linkage from the back of the door handle.
Left.
See the link for instruction and photos. >>>>>>>>>>>>>>>>>>>>>>>>>>>
I don't know - but the question about the 1993 door handle is the same...
Lift up on the handle. You should see plastic inserts that fit into two tiny holes. Remove the inserts and the handle should slide to the side.
Lift the door handle as though trying to open the door. You should see two pins going through the handle assembly. The pins can be pushed out, allowing you to remove the handle.
To remove the rear passenger door handle on a 2006 BMW X3, first, ensure the door is closed and remove any trim or cover concealing the screws. Use a Torx screwdriver to remove the screws securing the handle. After unscrewing, gently pull the handle outwards to disconnect it from the door. Finally, disconnect any electrical connectors if equipped, and the handle should be free for replacement or repair.
remove the outside handle by lifting the handle up and removing the small clip in the underside of the handle The inside door handle? remove the screw pull towards the front then out and release the clips holding the lock and open rods
To remove the passenger side headliner handle, start by gently prying off any plastic covers or caps that may be concealing the screws. Use a screwdriver to remove the screws securing the handle to the headliner. Once the screws are out, carefully pull the handle away from the headliner, ensuring you don't damage the surrounding material. If necessary, disconnect any wiring if the handle has integrated lights.
To remove the outer door handle on a 2008 Saturn Aura, first, ensure the door is open and locate the screws securing the handle, typically found in the door panel. Use a screwdriver to remove these screws, then carefully pry off the door panel to access the handle mechanism. Disconnect any linkage attached to the handle, and finally, slide the handle out of its housing. Reassemble in reverse order after replacing or repairing as needed.
Remove inner door panel for acess
To remove the outer door handle of a 2007 Saturn Ion, start by removing the door panel. This typically involves unscrewing several screws and carefully prying off the panel clips. Once the panel is off, locate the retaining clip or screw that secures the door handle and remove it. Finally, slide the handle out of its position and disconnect any wiring if applicable.