0
Which way to turn harmonic balance nut to remove on a twin overhead cam 1999 Saturn?
Wiki User
∙ 13y ago
Left.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you remove the harmonic balancer on a 300zx with an automatic transmission?
you buy a pulley grabber kit, make sure you get one large enough to fit over the harmonic balance. but be careful not to damage it, harmonic balances are expensive to replace.
How do you remove front passenger overhead handle on a Saturn?
pry up the cover from the outside of the handle and remove the 7 mm screws front and back
How to remove a harmonic balancer from a 350?
you should use a tool called a harmonic balance puller. the balancer came off in two pieces and the second piece that's still on the crank shaft won't come off
How do you remove harmonic balancer on 2000 cougar?
use a harmonic puller
On a Saturn whish way do you remove harmonic balancer bolt?
left aka Counter clockwise. It extremely tight so a breaker bar with pole on the end of it may be needed.
How do you remove the harmonic balancer in a Nissan Maxima?
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
How do you replace harmonic balancer on 1993 f 350 with 351 motor?
first remove serpintine? fan belt then remove large bolt in middle of harmonic balance. this bolt usually has left hand thread next with a harmonic pulley ,puller, remove harmonic balancer.when removing this, there is a key in the balancer and shaft if a new key did not come with new balancer,make sure not to loose the old one install new balancer with key.use the bolt to pull balancer up tight where it needs to be and use proper torque on bolt
How to remove crank pulley?
On most newer cars, the crank pulley is one piece with the harmonic balancer.... Remove it with a harmonic balancer puller.
How do you replace crankshaft position sensor on a 1988 olds 98?
To replace the crank sensor you have to remove the harmonic balance taking special attention not to damage the pulley or the cam shaft. Remove the two 10mm retaining screws
Remove the overhead console on s-10 blazer?
how to I remove the overhead console on the S 10 Blazer?
Where is the cam shaft located at on 1999 Saturn 1.9 engine?
The Saturn 4 cylinder engines were available in 2 styles, the single overhead cam and the dual overhead cam. In both engine types, the camshafts were always in the head, just under the top cover of the engine. If you remove the top cover (where you install the sparkplugs) you will see the camshaft(s).
How can you remove the Overhead console in a 2007 dodge ram?
To remove the overhead console you will first need to disconnect and isolate the negative battery cable. Remove the overhead screws and pull straight down on the console.
