first remove serpintine? fan belt then remove large bolt in middle of harmonic balance. this bolt usually has left hand thread next with a harmonic pulley ,puller, remove harmonic balancer.when removing this, there is a key in the balancer and shaft if a new key did not come with new balancer,make sure not to loose the old one install new balancer with key.use the bolt to pull balancer up tight where it needs to be and use proper torque on bolt
Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.
You will need to go through the passenger front wheel well (wheel off). Remove belt, remove pulley/balancer with a balancer puller tool. Air tools make this job MUCH easier.
Yes, located toward the bottom ot the engine at the end of the crankshaft. Mazda used an integrated harmonic balancer/belt pulley.
Check your timing belt, harmonic balancer and the either two or three belts that connect to the harmonic balancer
They are right handed. Turn counter clockwise to loosen.
ALL harmonic balancers for ALL American car engines (and all other vehicle engines that I know of) are in the same place. They're integral to the front engine pulley that drives the serpentine belt or fan-belt, whichever your engine has. Yours has a serpentine belt. Some shops call it the "harmonic balancer", others call it the "harmonic balancer pulley", still others just call it the "front pulley". It's the same thing.
remove top engine mount and cut off metal lug that stops engine from lowering enough to remove harmonic balancer. Then engine lowers enough.
do you mean the harmonic balancer...ok..to remove you need to remove the fan and shroud assembly. YOu may need to remove the radiator to get enough room to get a impact gun and a socket on the nut to remove the harmonic balancer if you dont have a impact you are going to have to lock the engine and get a large breaker bar and a socket on the nut and then remove the part.
behind harmonic balancer,front of engine(passenger side of car is "front") balancer is large pulley down low - must use harmonic puller to remove- DO NOT use standard puller or you will destroy it (costs about $300.00 to replace)then also need to remove cam-belt cover
power window motor removal 93 sunbird
You will have to replace it. The bearings are worn out in the blower motor.
There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!