answersLogoWhite

0

get in your back seat. feel along the bottom edge of your seat. you will feel two bolts. remove these and the seat will come right out. just did this to my 91 cutty to see if i could get to the fuel pump from there.

6

696

6969

12

12

dont listen to him...he cant spell

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How to remove the upper back seat from a 1994 Oldsmobile cutlass supreme?

First you remove the lower back seat, and the bolts that secure the upper will be exposed. Remove them and lift out upper back seat.


What type of tool do you need to reach spark plugs on back side of engine 3.1 94 olds cutlass supreme?

I have a 1991 Cutlass Supreme and I had to use a flex ratchet to replace the back 3 plugs. Other than that I was told by a mechanic friend that the motor has to come out to do this.


Where is the pcv valve located on a 1991 Oldsmobile cutlass supreme?

its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.


How do you remove a key from a car trunk lock on a 1991 Oldsmobile Cutlass?

grab the end of the key sticking out and pull straight back.


How do you change a blower motor on a 1995 cutlass supreme?

Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.


How do you reset the ECM on 1991 3.1L Cutlass after the battery dies?

remove the neg (-)battery pole and plug in back in about 5-10 minutes


Where is the gas cap on a 1984 cutlass supreme?

under the back license plate


Change radio Oldsmobile cutlass supreme?

Begin by removing the decorative radio retaining cover. Remove the retaining bolts. The radio will slide out. Remove the wiring harness and the antenna cable from the back of the radio.


How do you repair the timing on a 1991 Oldsmobile Cutlass Supreme 3.1 liter V6?

You can't, its done by the computer if you have a knock noise, replace the knock sensor. its locate on the back of the engine near the alternator.


Where is the plug to the lock up torque switch on a 1991 Oldsmobile Cutlass Supreme?

The plug for the lock-up torque converter switch on a 1991 Oldsmobile Cutlass Supreme is typically located near the transmission, specifically on the driver’s side. It is usually mounted on or near the transmission harness. You may need to trace the wiring from the transmission back to find the connector. Always consult a repair manual for specific diagrams and locations for your vehicle.


How do you remove radio from 93 cutlass supreme?

To remove the radio from a 1993 Cutlass Supreme, start by disconnecting the negative battery terminal to ensure safety. Next, carefully remove the trim panel surrounding the radio using a flathead screwdriver or trim removal tool. Once the panel is off, unscrew the radio mounting screws and gently pull the radio out of the dashboard. Finally, disconnect the wiring harness and antenna cable from the back of the radio.


Where is the fuel filter located on a 1990 cutlass supreme sl?

I have 90 cutlass supreme. look under center of car for gas tank. should be on back end of the tank. need to jack up high enough to get at.