The lower part just lifts straight up. It is clipped in the front. The seat back is bolted in. You can get to the bolts after removing the cushion.
No. you have to remove the tank.
Its under back seat
To remove the rear seat back in a 1992 Chrysler LeBaron Convertible, first, locate the retaining bolts at the bottom of the seat back; these are usually accessible from the trunk. Use a socket wrench to remove the bolts. Once the bolts are removed, gently pull the seat back upward and away from the seat base to detach it. Be cautious of any clips or connectors that may also need to be released.
It is between the rear seat back and the trunk. You have to remove the rear seat to access.
To remove the back seat of a 1989 Chrysler LeBaron convertible, first, locate and remove the seat bottom by pulling up on the front edge to release it from the clips. Next, for the seat back, look for bolts or screws at the base or sides that secure it; remove these using the appropriate tool. Once detached, gently lift the seat back upwards to release it from any remaining clips or hooks. Be sure to check for any seatbelt attachments that may need to be disconnected before completely removing the seat.
Push down and back on the front edge of seat, 1st on left side then on right side. Then pull entire seat section up and out.
Push back on the front bottom of the bench (takes a lot of pressure) to release clips Lift up to remove bench, this will expose clips or bolts holding the top of the seat in place Remove bolts or clips and push up on the rear of the seat to release upper clips to remove back of seat
remove back up tire in back right behind seat
Remove the screw at the back of the back seat, then the two screws that hold down the front seat and there is your battery. Please remove the negative cable first.
To remove the rear seat in a 1993 Chrysler LeBaron convertible, start by locating the seat cushion release clips or bolts at the front of the seat. Pull or unscrew these fasteners to detach the seat cushion, then lift it out. Next, access the rear seat back by locating the bolts or clips securing it to the vehicle frame, usually found at the bottom or sides. Remove these fasteners, and then gently pull the seat back away from the body to fully detach it.
To remove the rear seat from a 2007 Cadillac DTS Sedan, start by locating the release mechanisms at the front of the seat bottom; pull up on the levers or tabs to detach it. Once the seat bottom is removed, you can access the rear seat back. Look for bolts or fasteners securing the seat back to the frame, usually located at the bottom or sides, and remove them. Finally, lift the seat back upward to detach it from the vehicle.
To remove the back seat of a Chrysler LeBaron, start by locating the seat release mechanisms, which are usually found at the base of the seat or on the sides. Pull the release levers or bolts to detach the seat bottom. Once the bottom is removed, you can access the backrest, which may require unscrewing bolts or clips at the bottom before it can be lifted out. Always refer to the vehicle's manual for specific instructions related to your model.