Push in, on either side of the hump, about the middle of the bottom edge of the rear seat cushion. This will disengage the wire from the floor clamp. Lift up the cushion and remove from car. This maybe a little difficult using your knee for pushing may help. Remove the two bolts from the the wire loops at the bottom of the rear seat back rest and lift from the bottom. this will disengage the wire from the back rest clip. Reverse procedure to reinstall. These instructions will work for most GM cars 68-72 A-body (Monte, Chevelle. Olds, Buick, Cadillac) plus other applications.
1971 Chevrolet Monte Carlo
Chevrolet produced approximately 1900 or so of the 1971 SS454 Monte Carlo
The Old Car Manual Project provides the owner's manual for the 1971 Chevrolet Monte Carlo. In addition websites and forums dedicated to the Monte Carlo in general have specific information regarding the 4 engine types associated with the 1971 model.
The fuel economy of a vehicle is something that should be know by the driver. The 1971 Monte Carlo gets somewhere between 16 to 24 miles per gallon.
.035
The maximum speed of a 1971Chevrolet Monte Carlo automatic 8cyl 365HP is 127mph or 204.38kph.
It takes 5 quarts.
In a 1971 Monte Carlo, the heater fan is located under the dashboard on the passenger side of the vehicle. It is typically found within the heater box assembly, which is connected to the HVAC system. To access it, you may need to remove the lower dashboard panel or the glove compartment. Make sure to disconnect the battery before performing any maintenance.
Yes. It should bolt right in.
The bolt pattern on a 1971 Chevrolet Monte Carlo is 5x4.75 inches (5x120.65 mm). This means there are five bolt holes arranged in a circle with a diameter of 4.75 inches. This specification is common among many Chevrolet models from that era.
Its a 1971-72 Chevy Monte Carlo hard top
Could be a lot of reasons but we need more info on your problem to help.