Open the cup holder and remove the two screws on the outside.
4 sheet metal screws on top and pry out and in and it should pop out.
Pull the cup holder out as far as it will go. Pull up on the seat upholstery right above the cup holder so you can see the very back of the cup holder. There is a tab there. Push down on the tab while pulling out on the cup holder and it will slide right out. Reinstall by lining up in the slide rails and push it back in.
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
Don't bother. The new one will break soon too. Better to get an aftermarket one that clips to the front of the center console. Try Dieselmanor.com Good luck!
Remove original ashtray, remove 4 screws that hold ashtray mounting bracket. This will give access to the 2 screws that hold inner end of cup holder. The cup holder must be pulled all the way out to get to screws. Remove screws, remove 2 screws in front face, cup holder will come right out. Installed updated cup holder in 20 minutes, start to finish!
open your cup holder and on the top lip of opening there will be two screws, remove those then the center dash piece can just be popped off. then theres just four screws holding in the factory stereo.
Pull the cup holder out. Reach back, and at the top rear, center-left, is a tab. Press the tab down and pull out on the cup holder to remove it.
I cannot find how to remove the cup holder from the dash of my 2001 Pontiac Montana
To remove the cup holder in a 1998 Toyota 4Runner, start by prying off the plastic trim surrounding the cup holder carefully to avoid breaking clips. Once the trim is removed, locate the screws or bolts securing the cup holder in place and remove them. Gently pull the cup holder out of its slot. If it's stubborn, ensure there are no hidden fasteners and use a flat tool to assist in prying it out.
there are for screws that hold it on. Two on the ash tray. and two on the cup holders then there are two holding the radio in.
To remove the cup holder from a 2005 Acura RL, start by using a flathead screwdriver to gently pry off the trim panel surrounding the cup holder. Once the trim is removed, locate the screws or clips securing the cup holder in place and remove them. Carefully pull the cup holder out of its housing, ensuring not to damage any surrounding components. Reassemble by following the steps in reverse order.