To remove an electrical connector, first ensure that the power is turned off to avoid any electrical shock. Gently squeeze or press any locking tabs on the connector to release it, then pull it apart with a steady motion, avoiding excessive force. If the connector is stuck, check for any additional clips or tabs that may need to be released. Always handle connectors carefully to prevent damage to the pins or housing.
Removal and Installation Remove the trim panel. Release the clip. Release the locating tabs. Remove the trim panel. Disconnect the exterior mirror control switch electrical connector. Disconnect the exterior mirror electrical connector. Release the clip. Release the electrical connector. Disconnect the electrical connector. Remove the exterior mirror. Remove the bolt. If equipped, remove the screw. To install, reverse the removal procedure.
Remove the electrical connector from the old resistor. Remove the screws holding the resistor in place. Remove the old resistor. Put in the new one and screw in the screws. Attach the electrical connector.
Disconnect the electrical connector, remove the mounting screw and remove the sensor.
Door Speakers: * Remove the door trim panel * Remove the speaker mounting screws * Pull out the speaker and disconnect the electrical connector from the speaker and remove the speaker Door Subwoofers: * Remove the subwoofer grille trim panel * Remove the door trim panel * Remove the 8 mounting screws from the front side of the subwoofer * Remove the single subwoofer retaining screw from the backside of the subwoofer enclosure * Pull out the subwoofer,disconnect the electrical connector and remove the subwoofer Quarter Panel Speakers: * Remove the quarter panel trim * Remove the 4 speaker mounting screws * Pull out the speaker,disconnect the electrical connector and remove the speaker Parcel Shelf Speakers: * Working from inside the trunk area,disconnect the speaker electrical connector * Remove the parcel shelf * Remove the speaker mounting screws and remove the speaker
Remove the front bumper fascia.Unplug the horn electrical connector and remove the bracket bolt.
There is a spring clip that holds them on. Squeeze the clip and then pull the electrical connector off.
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt