0
What else can I help you with?
My Chevy trailblazer makes a whining noise that increases as the rpm's increase?
it is the idler pully. i just replaced mine and all the whining stopped
How do you replace an idler pulley on a 1999 Ford f150 4.2ltr?
first you should release the belt tension pully and remove the belt. Then the idler pully has a bolt through the center remove the bolt and the pully should come off.
How do you remove the fan unit on a peugeot 406?
Pin the top tension idler pully..take the front wheel off...the bottom idler pully is on an excentric...loosen same....belt goes slack.... put new belt on,set the excentric as tight as possible.. remove the pin in the top tension idler pully belt should be tight after doing this... happy days
What is an idler on a Honda?
Most technicians refer to the idler pully for the timing belt as just idler.
Squeak near serpentine belt on 2005 trailblazer?
It could be a bad bearing in the idler pully, A/C clutch, ect. Try turning on the A/C to see if it changes the squeek.
Can you Adjust the idler pully 1991 Chevy silverado?
No you can not. If belt is loose, are won't fit then you have the wrong belt. The belt tensioner is spring loaded and that is what tightens the belt.
After one has removed the AC from one's 1990 Chevy K3500 with 454 Where can a person purchase a replacement bracket and new idler pully to replace missing AC compressor?
Idler PulleyI recently replaced a idler pulley on my Chevy 305 v8 from Auto Air of Oklahoma. Their web site is www.autoairofoklahoma.com, you might try them, I looked everywhere for a idler pulley before I found these guys. TJ
Removal of water pump pulley 1994 Chevy cavalier 2.2?
I have a knocking noise near the water pump pully or idler arm pully on my 94 chevy cavalier 2.2 motor when its at idle, if i give it more gas the noise will go away do you know what this could be? i took off the tension idle pully and checked the bearing and it was fine.
How do you put a fan belt on a 1992 Chevy silverado?
a 92 Silverado 350 uses a single serpentine belt that is tensioned by a spring loaded idler pully. When facing the engine from the front of the vehicle, the tensioner is near the top of the engine slightly left of center. Using a breaker-bar and socket, remove tension from the idler pully and simultaneously slide the serpentine belt off one of the other pulleys. I usually pick the alternator pully since it's so close. Note the path of the old belt and make certain that the new belt is installed along the identical path. Put the belt on all pullies, including the idler pully and hold it with slight tension near the alternator pully, then turn the idler pully again and slide the belt over the alternator and release pressure from the idler pully. Visually inspect the path of the entire belt to make certain that it is properly installed before starting the engine. Don't let anyone stand to the side of the engine when starting it for the first time, since a mis-installed pully can be ripped apart quickly and relatively large pieces of reinforced rubber can really hurt when they hit you.
How do you fix a broken serpentine belt pulley on a 1998 2.2liter Chevy cavalier?
remove the bolt on the pully or use a pully remover depending on the style of pully and put new one on.
Replacing an idler pulley on a 93 Jeep Cherokee sport?
Unbolt, slide off. Slide on new part, bolt back on.
How do you change the serpentine idler pulley serpentine tensioner and serpentine belt on a 1999 Nissan ALtima?
remove belts idler is to close to fire wall to come off after you remove nut.jack up car and put stands under.how put a jack under engine . remove top motor mount bolt and jack engine up this will give you the room to change idler pully.
