0
there is a few screw to the front panel where the instuments are,remove them. them there will be a few smaller, I think their 11/32 screw heads,remove them after all that is undione the cluster should move around freely.DONOT PULL HARD ON IT! lower down the steering colomn then reach inbehind and remove necissary wiring and speedo cable. after that reverse the procedure and away you go on the road back to completion.
What else can I help you with?
How do you change a Chevy S-10 instrument panel light?
remove the trim panel around the instrument cluster then remove cluster. On the back of instrument cluster are the bulbs just turn them half a turn and they come right out.
How do you change the in dash heater control on a 1998 Chevy blazer?
Remove the two screws at the top of the instrument cluster. This will allow you to pull out the entire bezel. Pull out the bezel, and pop the switch out from the bezel.
How do you replace the service engine bulb in a 1987 Chevy Celebrity?
You have to remove the instrument cluster to service the light bulbs.
How do you remove the instrument cluster on a 1962 Chevy?
In most 1962 Chevys, the instrument cluster is screwed in from the front. After removing the screws wiggle gently and look to see if any wires or the speedometer cable needs to be unhooked.
Is the speedometer on a Chevy Blazer electronic or by cable?
I believe that the first digital cluster on a S-10 Blazer was in 1989.
How do you remove the cover to a 2001 Chevy Blazer Steering wheel column?
How to Remove the Steering wheel From a Chevy Blazer 2001
How do you remove the dashboard of a 2002 LS Blazer?
how do you remove the dashboard of a 2002 Chevy blazer
How do you remove the instrument panel from a 1994 Chevy s10 blazer Tahoe lx?
If your looking to remove the entire dash assembly I would recommend purchasing a shop manual to guide you thru it.
Remove gage cluster to replace bulbs in 1992 Chevy Cavalier Z24 3.1 MPFI?
Remove the the switches on both sides of the cluster by pulling straight out then remove the two screws between the cluster and the steering column. After those are removed pull the instrument cluster cover towards you(may be hard to get out so pull hard) then their will be 2 more screws to remove the cluster and on the back of the cluster are several twist clips that hold each bulb in the cluster. The bulbs are #194.
How do you change a light bulb in the instrument panel cluster on my 1988 Chevy G20 van?
To change a light bulb in the instrument panel cluster of your 1988 Chevy G20 van, first disconnect the battery to ensure safety. Remove the dashboard cover by unscrewing any screws or clips, then carefully pull out the instrument panel. Locate the burnt-out bulb, twist it counterclockwise to remove it, and replace it with a new bulb. Reassemble the instrument panel and dashboard cover, then reconnect the battery.
Where is a amp on a 1999 Chevy Suburban?
On mine, its behind the dashboard instrument cluster.
Ignition in a 2000 Chevy Malibu?
remove instrument cluster, remove 2 screws holding switch in, push switch about 1 inch straight back to clear mounting bracket. pull straight out.
