0
The tail light lens on a 1989 Chevy Celebrity is part of the tail light fixture and cannot be conveniently removed. If you want to change a light bulb you have to remove the tail light fixture from the car. To remove the tail light fixture:
1. In the trunk next to the quarter panel are three nuts, remove the center nut. It should be in the center of the tail light fixture.
2. Pull the tail light fixture so that the stud comes out of the body, then pull outward to pull the tab out of the backup light fixture.
3. You can now take the appropriate socket out and replace the bulb.
Reverse the steps to replace the light fixture.
What else can I help you with?
Where is radiator petcock on 1989 Chevy Celebrity 2.8?
The petcock on a 1989 Chevy Celebrity is at the bottom of the radiator on the drivers side.
How do you remove the front speakers from a 1989 Chevy Celebrity?
To remove the front speakers from a Chevy Celebrity: 1. Take out the screws from the speaker grills, take the grills out. 2. The speaker is held in with screws, remove them. Lift the speakers out of the dash and unplug the wire harness.
Where is the O2 sensor on a 1989 Chevy Celebrity?
The oxygen sensor on a 1989 Chevy Celebrity is located in the rear exhaust manifold on top about the center.
Where to find power accessory relay on 1989 Chevy Celebrity?
Looking in my factory service manual for a 1989 Chevy Celebrity I found no reference to an accessory relay.
What is the spark plug gap for a 1989 Chevy Celebrity 2.8 v6 engine?
The spark plug gap for your 1989 Chevy Celebrity 2.8 V6 is .045".
What is the horse power on an 1989 Chevrolet Celebrity v6?
The 1989 Chevy Celebrity V6 is rated at 130 hp.
Must you remove the camshaft to replace the timing belt of a 1989 Chevy Celebrity 4-cylinder?
no The Chevy Celebrity 4 cylinder engine doesn't use a timing belt, it uses a timing gear. To replace the gear it is necessary to remove the camshaft from the engine as it is a press job. To remove the camshaft it is necessary to remove the engine from the car.
You need to know how to remove the crank shaft positioning sensor for a 1989 2.8 lt. Chevy Celebrity with a V6 Thanks?
The answer depends on what engine you have.
How do you remove the rear panel in a 1989 Chevy Celebrity to replace a tail light?
To remove the tail light fixture on a 1987 to 1990 Chevy Celebrity sedan: 1. Inside the trunk next to the quarter panel are 3 nuts. Remove the center nut, it should line up with the center of the tail light fixture. 2. Pull back on the tail light fixture until the stud clears the body. 3. Pull outward on the tail light fixture to remove a tab from the back up light panel. 4. Twist the appropriate socket counter clockwise and remove it. You can now replace the light bulb. Reverse the process to put the tail light fixture back in place.
Where is the modulator valve on a 1989 Chevy Celebrity?
on the side of the transmission
Where is the altrenator fuse on a 1989 Chevy Celebrity?
There is no fuse on the alternator.
Where is the thermostat located on a 1989 Chevy Celebrity?
The thermostat on a 1989 Chevy Celebrity is located under the water outlet fitting. Follow the upper radiator hose, it will end at the water outlet.
