Under the right side of dash behind panel between pass dorr and firewall
how do you repace the Ignition Module
yes, it will
the gross vehicle weight rating of a 1989 Chevrolet 2500 pickup is 8,600 lbs.
Down the tube where the trans dipstick is. Use a long funnel that fits into this hole.
The location of the EGR valve on a 1987 to 1989 Chevy Celebrity depends on which engine the car has. If the car has the 2.8L V6 the EGR valve mounts to the plenum near the throttle body. If the car has the 2.5L 4 cylinder engine the EGR valve mounts in the center of the intake manifold near the valve cover.
When you shake the PCV valve it should rattle. If it does not rattle then it is probably stuck and should be replaced.
The vacuum modulator on a 1989 Chevy K-1500 4wd 5.7 is underneath the transmission. It can be reached from under the car.
The petcock on a 1989 Chevy Celebrity is at the bottom of the radiator on the drivers side.
On your 1989 Ford Ranger : The vacuum modulator valve is on the passenger side of the A4LD automatic transmission ( it might be behind a heat shield )
The PCV valve is on top of the rear valve cover. The air intake plenum extends over the top of the valve making it difficult to see.
The oxygen sensor on a 1989 Chevy Celebrity is located in the rear exhaust manifold on top about the center.
The 1989 Chevy Celebrity V6 is rated at 130 hp.
Looking in my factory service manual for a 1989 Chevy Celebrity I found no reference to an accessory relay.
The spark plug gap for your 1989 Chevy Celebrity 2.8 V6 is .045".
There is no fuse on the alternator.
The thermostat on a 1989 Chevy Celebrity is located under the water outlet fitting. Follow the upper radiator hose, it will end at the water outlet.