Open the lift gate , remove the ( 2 ) screws at the top of the taillight , carefully work
the taillight straight back towards you ( it has plastic pins >>>>>>>> that hold it in
place and you don't want to break any of those ) The bulb sockets are a simple turn to
release
Remove the taillight assembly to gain access to the bulbs
Remove bedliner( if applicable). You must remove the taillight framing to get to bulbs. There are two screws located behind the taillight, that must be unscrewed to loosen the taillight frame from the truck body. Remove the two screws via the truckbed side and framing will loosen and bulbs can be replaced.
To replace the rear bulb in a Toyota 4Runner remove the plastic covers located in the trunk. Taking off the plastic covers will reveal the taillight housing and bulbs. Replace the bulbs.
remove carpet trim in the rear of the trunk remove the screws behind the carpet and the taillight should pull right out
The taillight bulbs can be easily replaced on a Honda Civic. Open the trunk and locate the plastic covers. Remove the plastic cover and pull the bulbs. Replace with new bulbs and install the covers.
Lift the hatchback and remove the 2 screws holding in the taillight assembly. You can then access the light bulbs from the rear.
you have to go through the trunk remove the apolstery and you wii\ll see were the bulbs screw in the lens
Drop the tailgate, access the screws to remove the taillight assembly. Remove the screws holding the circuit board to the assembly, pull the board and you will have access to the bulbs.
To change the park light on a Subaru Impreza prop the trunk lid open and locate the taillight housing. Remove the plastic cover and the bulbs for the parking lights. Replace the bulbs.
you need to remove the tail light lens. There is a large round plastic cap located behind the lens in the truck .Remove the cap and there is a black plastic nut that you can remove by hand, that will release the lens and you will be able to replace the bulbs.
* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
Remove access panel in trunk area--Wing nuts should release taillight assembly and bulbs twist out