remove the tiny C clip from under the winder 1.25 1996 N. don't rip it off like I did.
How to remove Window Winder Handles from VZ Holden Commodore
To remove the window winder on a Ford Fiesta from the P-reg era, first, carefully pry off the small plastic cover at the base of the winder handle using a flathead screwdriver. Once exposed, you'll find a retaining screw that needs to be unscrewed. After removing the screw, pull the winder handle straight off the shaft. If it’s tight, gently wiggle it while pulling to free it from the splines.
Begin by removing the inside door panel. Remove the linkage from the window winder. Remove the window winder retaining bolts. The window winder will come off.
Between the window winder and door card there should be a plastic ring about 8mm wide. Push this ring away from the end of the window winder. The windes should now slide off
To remove the window winder on a VW Lupo, first, ensure the window is fully closed. Use a flathead screwdriver to carefully pry off the plastic cover at the base of the winder handle. Once the cover is removed, you'll find a retaining clip or screw that secures the winder; remove it using the appropriate tool. Finally, gently pull the winder off the shaft to complete the removal.
Just pull it!
take it to safelite lol
With a knife. A sharp one.
Look at both ends of the wiper, there should be two little metal clips made into the rubber, you squeeze them together and pull out the blade. If they have been replaced, they might be plastic.
To remove the window winder on a VX Commodore, first, use a flathead screwdriver to gently pry off the decorative cover from the winder handle. Once the cover is removed, you’ll see a small retaining clip or screw that holds the handle in place; you can either unscrew it or carefully remove the clip with the screwdriver. After that, simply pull the window winder off the shaft. If it’s stuck, you might need to wiggle it back and forth while pulling.
To remove the window winder on a Daewoo Matiz, first, use a flathead screwdriver to carefully pry off the decorative cap from the winder handle. Once the cap is removed, you will see a retaining screw; unscrew it using the appropriate screwdriver. After the screw is removed, pull the winder handle off the spindle. If it’s stuck, gently wiggle it while pulling to free it.
The window winder is secured by a spring wire clip. Push the circular pad away from the winder handle and pull out the clip with a crochette hook or similar.