The rear fog lights are accessable from under the car. You have to reach up and under the rear bumper.
I had this problem, the lights around the tach were out. Are you ready for this? You have to replace the entire dash assembly! Mine was done by the dealer I bought my used 2001 Aurora from, Chattanooga Saturn. It would have been several hundred dollars. I am grateful to Saturn of Chattanooga! Andre'
on my 99 aurora the lights are auto i dont touch them and the tail light stay on to
how to replace the power steering hose on a 2001 oldsmobile aurora 3.5 liter engine
They are burned out.
To replace the bumper cover on a 2001 Mitsubishi Mirage, start by removing any screws or bolts securing the bumper, typically located in the wheel wells and underneath the bumper. Carefully detach the clips and connectors for any lights or sensors. Once all fasteners are removed, gently pull the old bumper cover away from the vehicle and align the new cover in place, securing it with the original hardware. Finally, reconnect any lights or sensors and ensure everything is properly fitted before tightening all fasteners.
how to 2001 highlander grille
== == == == you don't it's molded int to the bumper.
To replace the front bumper on a 2001 Buick LeSabre, first, open the hood and remove any screws or fasteners securing the bumper to the vehicle frame. Next, disconnect any electrical connectors for fog lights or sensors. Carefully pull the bumper away from the vehicle, ensuring that you detach any clips or brackets. Finally, install the new bumper by reversing the removal steps, securing it with screws and reconnecting any electrical components.
well if its anything like my 99' it is soldered in. i found out when i changed out my lights to blue leds. gonna have to solder a new on in!
How do I replace the dash panel lights on a 2001 toyota sequoia?
Very carefuly.
Fog lights use special brackets which sit recessed on a 2001 Chevy Cavaliers bumper. To install the fog lights mount the units into the bumper brackets. Then splice the fog lights into the existing wire harness. Use a switch if necessary.