# Disconnect and isolate the battery negative cable. # Remove the screw that secures the inboard side of the front park/turn signal lamp unit to the front bumper fascia. # Pull the inboard side of the lamp away from the fascia far enough to disengage the tab that secures the outboard side of the lamp from the slot in the front bumper fascia. # Disengage the lock feature and disconnect the wire harness connector from the lamp socket. # Remove the front park/turn signal lamp unit from the vehicle.
replace bulb in front
You need to remove the head lap it has some scews on the side and on front.
u go ask a mechanic to do it then pay them for it
take all the clips out i believe its like 13 then clip out the grill and u set to go
If you are talking about a front turn signal, there is a release tab inside the fender. when you push it it will release the whole light assembly. Then you can access the bulb
Replace the rear bulb and be sure the contacts are clean.
you have to open up the hood and take out all the junk and put in the new bulb.
there are two screws holding the light assembly to the car. Remove the two and replace after removing headlight
how to replace ac hose assembly on 2005 jeep liberty
How to replace left front door actuator on a 2005 honda accord hybrid
To remove signal (corner) light. the light is able to come off by pulling it towards you facing the vehicle. once popped off the light has a plug attached to it, remove it cautiously.
To replace the front turn signal light in a 2005 BMW X5, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, then gently pull it out to access the bulb holder. Twist the bulb holder counterclockwise to release it, replace the old bulb with a new one, and reassemble by reversing the steps. Ensure the assembly is securely in place and test the new bulb before closing the hood.