0
To replace the heater control valve on a 2000 Chevy Silverado, start by disconnecting the negative battery cable to prevent any electrical shorts. Drain the coolant from the radiator, then locate the heater control valve, which is usually found near the firewall in the engine compartment. Disconnect the hoses attached to the valve and remove the mounting bolts, then install the new valve by reversing the process. Refill the coolant, reconnect the battery, and check for leaks before starting the engine.
What else can I help you with?
Where is the heater blower located on a 2002 Chevy silverado?
The heater blower for a 2002 Chevy Silverado is mounted under the dash. It is on the passenger side, in the heater housing.
Replace fuel filter 2008 Chevy Silverado?
replace fuel filter 2008 Chevy silverado
How do you remove and replace a heater core on a 1999 Chevy silverado?
buy a Chilton manual and it will tell you most of what you need to know.
Replace switch that control fan speed for vent in Chevy silverado?
Change blower fan control switch in the dash
What does the ecm control on your Chevy k1500 silverado?
What all does the ECM computer control on my 2006 Chevy k1500 Silverado
How do you replace fuel injectors Chevy Silverado?
how do i reinsert the fuel injectors on my 4.3 Chevy silverado
Replace heater core in 1997 Chevy blazer?
how to replace a heater core in a 1997 Chevy blazer
How do you fix the heat a 99 Chevy Silverado?
Check coolant level Test and/or replace thermostat Make sure heater core is not plugged restricted, or air bound Make sure coolant is being circulated by water pump Check heater control switch and /or cable
Where is the heater inlet hose on a 2002 Chevy silverado?
The heater inlet hose is on the firewall. On the 2002 Silverado it is close to the bottom of the firewall on the passenger side.
How much to put a heater core in a 95 Chevy silverado?
10000.00
How do you replace heater core in a 91 Chevy truck?
replace heater core in a 1991 Chevy work truck 1500
How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
