To replace the passenger side CV axle on a 1992 Ford Tempo, first, safely lift the front of the vehicle and support it with jack stands. Remove the wheel, then disconnect the lower control arm and any necessary components to access the axle. Remove the axle nut and pull the axle out of the hub, then slide it out of the transmission. Install the new axle by reversing the process, ensuring all fasteners are properly torqued.
Easy fix!
buick roadmaster 1992 rear axle does it have limited slip diff
this is a 4x4
what size socket for front axle nut 1991 ford tempo
what size socket 92 ford tempo front axle
To replace the passenger side drive axle on a 2003 Mazda 6, start by safely lifting the vehicle and removing the front wheel on the passenger side. Disconnect the lower ball joint and any necessary components to gain access to the axle. Remove the axle nut and pull the axle out of the hub, then slide the inner end out of the transmission or differential. Install the new axle by reversing the steps, ensuring all components are securely reattached and the axle nut is properly torqued.
The vss is on top of the trans-axle, behind the engine on the passenger side.
a typical shop will charge between $200 and $250
It should be mounted underneath the van, over the rear axle on the passenger side.
I don't think that will work unless you change over to rear disc brakes, the hub should not match.
Take off brake caliper and then hit the rotor with a hammer near the wheel bearing to break the seal between the rotor and axle shaft
you have to start by pulling out the driver side then dropping the pod out of the center of the Dana 27 to take out the c clip then the axle should pull right out