0
Open tailgate and use a #20 Torx screwdriver to remove two screws located on the inner side tail light assembly. On the driver's side, the screws are accessable through the tailgate hinge area with the gate open.
Pull taillight assembly straight back from the vehicle to get it off. You may need to utilize a wedge to gently work the top and bottom of assembly away from vehicle on outer side. If so, be careful to use plastic wedge or a protective layer (such as a thin piece of cardboard) next to the body to prevent scratching the paint.
Once removed, twist applicable light cover counter clockwise and pull to access lightbulb.
You may want to apply a small amount of lithium grease to the two plastic stud holes before reinstalling the cover to make it easier to remove the next time.
What else can I help you with?
2003 Jeep Liberty parking lights?
replace rear tail light bulb
How do you replace a Jeep Liberty tail light?
Trying to replace passenger side tailight on a 2002 Jeep Liberty. Cannot disconnect the plug and the replacement connector looks different from the original! Thanks Jim
How do you change the rear taillight bulbs and or get the taillight lens off on a 2006 Jeep Liberty?
The 2006 Jeep Liberty rear tail light lens does not come off. The tail light is seal. You can access the tail light lightbulb through the back of the tail light, in the cargo compartment.
What is the part called on a Jeep Liberty 2005 that holds the passenger brake and tail lights?
Tail light lens, or assemble.
Will the tail lights from a 2004 Jeep Liberty fit on the 2006 Jeep Liberty?
yes
What is color code for tail light wiring on 2004 jeep liberty?
In a 2004 Jeep Liberty, the color code for the tail light wiring is typically as follows: the left tail light uses a brown wire for the tail light and a yellow wire for the turn signal, while the right tail light uses a brown wire for the tail light and a green wire for the turn signal. Always refer to a specific wiring diagram for your vehicle or consult a repair manual for the most accurate information.
What is the correct screw driver head and size for Jeep Liberty tail light assembly bolts?
TORX T-15
You had to replace the right side taillight in your 2002 jeep liberty All the lights work except for the park light Any suggestions?
Check the fuse, it is a separate fuse for the right and left side as well as for the tail light and turn signals.
How do you replace a 2007 jeep taillight bulb?
take the screws out if the tail light and pull the old one out
Right turn works but left turn doesn't on my 2002 jeep liberty why?
Is your tail light out? Is the relay good? Replace the bulbs in your tail lights, should cost about $4. If that does not do it, go to your local parts store and buy a new relay. Rarely a bad switch.
How do you Replace brake light on 2007 jeep commander?
To replace the brake light on a 2007 Jeep Commander, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips securing the tail light, then gently pull it away from the vehicle. Disconnect the wiring harness and remove the old bulb by turning it counterclockwise. Finally, insert the new bulb, reconnect the wiring, and reattach the tail light assembly.
How do you change the taillights on a 2004 Jeep Liberty?
there are 2 torx head screws that hold the tail light on. you will need to open the back gate to get to them. then there are two snap connectors that hold the tail light to the body. you will need to pull straight back torward the rear of the jeep to get these to come loose.
