How do i replace brake lines on a 2000 grand am
measure affected line
Length of back brake line to replace. hole in it between front and back door
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car to the ground.
Replace the brake line, bleed the brake. top up with brake fluid. Done.
Check your rear U-Joint, plus the fluid level in your rear end. Also on my Aerostar, in my brake assembly I found a broken brake spring. If it is the gears in the rear-end you may have to replace. Good luck!
depends where the leak is. In the brake line or at the pump? electric or mech brakes? if its in the line you should be able to replace the line section
replace brake line the damage to the line or if the jb weld gets into the line it will affect how the system works.
To replace the brake line on a 1999 Mercury Sable, first, safely lift the vehicle and secure it on jack stands. Locate the damaged brake line, then use a line wrench to disconnect it from the brake components and remove any mounting clips. Cut and replace the line with a new pre-bent brake line, ensuring proper routing and securing it with clips. Finally, bleed the brake system to remove any air before testing the brakes.
Remove the line and replace it. Then make sure to keep the master cylinder full while you & a helper bleed the front brake caliber. Be sure and use brake line tools and not open-end wrenches or you will damage the brake lines.
replace the line and fill and bleed breaks.
which fuse triggers 1992 ford aerostar