There are two bolts nuts,one on each side of distributor at its base,remove and pull out,make sure you realign the new distributor with same way it came out along with the spark plug wires
You have to replace the distributor assembly.You have to replace the distributor assembly.
no
How do you replace the ignition distributor on a 93 mx6 v6 pics?
The cam shaft position sensor is located under the distributor cap. You can replace this easily by undoing the screws holding on the distributor cap, remove and replace the sensor, then just replace the distributor cap.
On the 2000 model it is part of the distributor and you either replace complete distributor or try to dismantle the distributor and replace sensor only.
The cam sensor is part of the distributor. You have to replace the entire distributor.
the faulty part is actually located in the distributor so you need to replace the whole distributor
It is part of the distributor. You have to replace the distributor
buy a new distributor
Inside the distributor. Replace the whole distributor.
To replace the distributor on a Mercedes 190E, first disconnect the battery to ensure safety. Remove the distributor cap and note the positioning of the wires for reinstallation. Unscrew the distributor from its mount, carefully lift it out, and replace it with the new unit, ensuring it aligns correctly with the engine timing marks. Finally, reconnect the wires to the new distributor, reattach the cap, and reconnect the battery.
there is no distributor on a 98 rav. therefore no cap or rotor. replace the plugs and wires and the tuneup is done