To replace the heater core on a 2003 Pontiac Aztek, first, disconnect the negative battery cable and drain the cooling system. Remove the dashboard and the center console to access the heater core housing. Disconnect the heater core hoses from the firewall, unbolt the heater core from its housing, and then replace it with the new core. Reassemble everything in reverse order, refill the cooling system, and check for leaks.
Your Aztek heater core is dead center of the car behind the dash/floor console.
AnswerCould someone post directions on how to change the thermostat on a 2002 Pont. Aztek? Is it any different than a 2003?It shouldn't be any different....
To replace a turn signal switch on a 2003 Pontiac Aztek, also known as a flash relay, the steering column must be removed. The flash relay is located under the turn signal. Remove the mounting hardware and the unit can be taken off.
do you need to remove dashboard in 2003 chevy impala to replace heater core
how to replace a heater core on a 2003 Nissan Altima 2.5
how do you change a heater core on a 2003 ss Monte Carlo
Trying to repair a heater core can be a waste of time. Just replace it with a new one.
i have an 03 aztek. i change plugs myself, i have skinny arms to reach from underneath the car.
On a 2003 Pontiac Aztek, the engine block heater is typically installed in the engine block, specifically at a freeze plug location. It is usually located on the passenger side of the engine, near the front. To access it, you may need to remove some components or covers, depending on the specific layout of the engine compartment. Always refer to the owner's manual or a service manual for detailed instructions specific to your vehicle.
where do i find the low side service port on a aztek
23