0
'm guessing you have a CEL code 23. The Knock sensor is behind the block (under the intake) and should screw out and you can chuck the new one in. I would personally make sure it's tight and check the wire from it to the ECU isn't loose or damaged before replacing it. Hope this link helps http://www.Honda-tech.com/showthread.php?t=1522364
What else can I help you with?
Where is the knock sensor in a 97 Nissan Pathfinder and how can you replace it?
The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.
Where is the knock sensor located on a Mitsubishi eclipse 97?
where is located theknock sensor 97 mitssubishi eclipse
Where is the knock sensor in a 97 Subaru Outback?
the knock sensor in on the drivers side of the block toward the rear, and it's under the intake manifold.
How do you install knock sensor in a 97 ford expedition?
On the 5.4 the knock sensor is under the intake and the connector is in the back of the motor on the passenger side.
How do you replace the throttle position sensor on a 97 Nissan altama?
how to replace the throttle position sensor on a 97 nissan altama
Diagnosing engine knock in 97 astro van?
check the anti knock sensor on the side of the motor
Where is the knock sensor located on a 97 Honda civic ex?
ihsiqwhdiqwehudhejkdjbdjkgbekd
How do you replace the fan motor on A 97 Honda Prelude?
You cant replace it, it's all in one piece.
Where is the knock sensor on a 97 diamante?
Your knock sensor is located under the hood, center, front engine area, below intake manifold, mounted on block.
Where is the knock sensor in a '97 Expedition?
if you have a 5.4 or a 4.6 it is under the intake manifold on the passenger side.
Where is knock sensor 97 Yukon?
It is screewed into the passenger side of the engine block just in front of the starter.
Where is knock sensor on a 97 Chevy 1500with a 5.7l?
The 1997 Chevy 1500 pickup truck 5.7 liter engine knock sensor can be found on the front of the engine. You will need to remove the front engine cover in order to access the sensor.
