0
To change the bulbs all you have to do is put a flat blade screw driver on the right side of the bulb housing and gently push to the left. This will release the catch holding it in and it will drop out and down on the end of its wiring connector. 1/4 turn the bulb and remove. Replace the bulb and just put the housing back into the opening left side first, then just push up on the right side till you hear a click. Takes about 1 min per light. Works for all Deville types 00-08
The only place I found replacement bulbs besides the Cadillac dealer ($32.00) for 2 bulbs was NAPA Auto Parts ($5.00) for 2 bulbs, On my 2004 Sedan Deville the release is to the left side of the housing.
What else can I help you with?
Where is the fuse for license plate lights on 2004 Cadillac deville?
The fuse for the license plate lights on a 2004 Cadillac DeVille is located in the fuse box under the rear seat. To access it, lift the rear seat cushion and remove the cover of the fuse box. Look for the specific fuse labeled for the license plate lights; it is typically marked in the diagram on the cover. If the fuse is blown, replacing it should restore power to the license plate lights.
How can you repair a 1998 cadillac deville license plate light?
my name is Jesse fondotsto replace a license plate light you first have to open the trunk of the car take out the carpet on the top of the trunk after that you will see two little black screws you take them out after you do that the silver peice will come off but before you can replace it you must take the two little screws out that are located right above the license plate. your welcome!
Where is the fuse for the rear license plate on a 2000 Cadillac deville?
what is the number for the fuse to change the rear license plate light. and is it the fuse box under the back seat or under the hood? The plate light is protected by the parking/tail light circuit.
How do you replace the license plate light bulb on a 2008 Cadillac STS?
if your under miles its under warrenty
How do you fix the fuse to the license plate bulb on 1994 cadillac deville?
pop your hood and find the what "FUSE PANEL" find the fuse marked Parking lights and replace it. Its that simple. it might not be a fuse have you replaced the bulb or checked your contacts from your wiring?
How do you change the licence plate bulb in a 2001 cad deville dts?
To change the license plate bulb in a 2001 Cadillac DeVille DTS, start by opening the trunk and locating the license plate light assembly. Carefully pry off the light cover using a flathead screwdriver or similar tool. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb, ensuring it’s securely in place. Finally, snap the cover back on and test the light to ensure it's working.
How do you replace license plate bulbs on 2003 cadillac deville?
pop out the light assembly with a screwdriver and change the bulb. your receptacle may be taking in water at the car wash. duct tape over lens before going through automatic car wash.
Where is the ecu located in a 1993 cadillac Deville?
The ECU on a 1993 Cadillac Deville is behind the glove box. To remove the ECU, remove the bolt and pull down the plate.
How do you replace a licence plate lamp on a 1989 Cadillac deVille?
This is an easy one, but.... I spent a good half an hour figuring it out. The license plate lamp requires no tools to replace. Above the license plate is a small bulb housing. At the back of the bulb housing is the bulb socket that locks into place. Simply turn the socket 90 degrees moving the socket clockwise as you're facing the rear of the car and wiggle it out. The bulb simply pulls out and the new one pushes in!
How do you replace license plate bulb on 1999 Cadillac Seville STS?
To replace the license plate bulb on a 1999 Cadillac Seville STS, start by opening the trunk and locating the license plate light assembly. Carefully pry off the lens cover using a flat screwdriver or a similar tool. Remove the old bulb by twisting it counterclockwise, then insert the new bulb by twisting it clockwise until secure. Finally, replace the lens cover and ensure it snaps back into place.
How do you remove water from the rear license plate light on a 2003 Cadillac DeVille?
To remove water from the rear license plate light on a 2003 Cadillac DeVille, first, remove the light assembly by unscrewing the retaining screws. Once the assembly is free, you can carefully drain the water by tilting it or using a small sponge or cloth to absorb the moisture. Afterward, allow the assembly to dry completely before resealing it with silicone sealant to prevent future leaks. Finally, reattach the light assembly securely.
How do you replace license plate bulb on cadillac DTS 04?
To replace the license plate bulb on a 2004 Cadillac DTS, first, open the trunk and locate the license plate light assembly. Use a flathead screwdriver or a similar tool to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reattach the lens cover. Finally, close the trunk and test the new bulb to ensure it works properly.
